CWNP CWDP-303 Online Practice Questions and Exam Preparation

CWNP CWDP-303 Online Questions & Answers

• Question 11:

  Your customer requires fast secure roaming. Which two types of roaming are specified in 802.11-2016 FT roaming that will help meet this goal?

  A. Over-the-Air and Over-the-DS
  B. Over-the-Air and Over-the-Wire
  C. FT and OKC
  D. FT and TKIP
  A. Over-the-Air and Over-the-DS

• Question 12:

  What metric implements the simplest algorithm and lowest accuracy in networks requiring locations?

  A. Angle of Arrival (AoA)
  B. Time of Arrival (ToA)
  C. Time Difference of Arrival (TDoA)
  D. Received Signal Strength Indicator (RSSI)
  A. Angle of Arrival (AoA)

• Question 13:

  You are conducting a physical site survey where heavy machinery is repaired. What is a common item required specifically for this type of survey?

  A. Personal Protective Equipment (PPE)
  B. Low gain antennas
  C. Low power APs
  D. Indoor APs
  A. Personal Protective Equipment (PPE)

• Question 14:

  What kind of site survey helps you identify if roaming is working as designed?

  A. Passive
  B. Predictive
  C. Active
  D. Spectrum analysis walkthrough
  A. Passive

• Question 15:

  What document is typically created to launch a project?

  A. Bill of Materials
  B. Project Charter
  C. Work Breakdown Structure
  D. Budget
  B. Project Charter

• Question 16:

  A company wants to connect its headquarters to its remote office that is 13 kilometers away using a wireless bridge. What requirement must not be forgotten by their Wireless Engineer when considering the Fresnel Zone?

  A. Earth bulge
  B. Antenna gain
  C. FSPL
  D. Receive sensitivity
  A. Earth bulge

• Question 17:

  When doing some frame capturing over the air during a voice call, you realized that frames on the downlink (from the AP to the client) direction are not being transmitted with the correct UP value for voice frames, but on the uplink (from the client to the AP) direction are being transmitted correctly. What's the cause of this issue?

  A. Bad client driver
  B. AP is not receiving enough PoE, thus not using QoS features
  C. Somewhere on the wired network QoS markings aren't being trusted
  D. Faulty antenna on the AP
  B. AP is not receiving enough PoE, thus not using QoS features

• Question 18:

  Your new customer is concerned about maintaining privacy for their proprietary information when you conduct information gathering for their WLAN design. Which document can you use to directly address their concern?

  A. NDA
  B. SoW
  C. BoM
  D. Hold Harmless
  A. NDA

• Question 19:

  A controller-based WLAN infrastructure has its controller on a different subnet than its APs. What device must be used to enable any communication between the Controller and the APs?

  A. NTP server
  B. Router
  C. PoE Layer 2 switch
  D. Wireless bridge
  B. Router

• Question 20:

  During a validation site survey, you realize that the installers mounted some of the APs above the ceiling. They said that this was a request from the building architect due to aesthetics constraints. During the requirements gathering, you weren't advised about any aesthetics constraints from the main stakeholder of the project. What should you do in this case?

  A. Advise the stakeholder that WLAN performance requirements will not be met and a new design process will be needed to meet the requirements.
  B. Leave it as it is and allow automatic channel management to correct any issues.
  C. Increase the output power on all APs by 6 dB immediately.
  D. Remove all external antennas and use only the internal antennas to reduce multipath.
  A. Advise the stakeholder that WLAN performance requirements will not be met and a new design process will be needed to meet the requirements.