Six Sigma CLSSBB Online Practice Questions and Exam Preparation

Six Sigma CLSSBB Online Questions & Answers

• Question 291:

  The principle disadvantage of fractional factorial experiments is that:

  A. experimental error is high
  B. robustness is compromised
  C. effects are confounded
  D. measurements are less precise
  E. analysis is more difficult
  C. effects are confounded

• Question 292:

  

  This is an example of part of a:

  A. QFD Matrix
  B. Activity Network Diagram
  C. Interrelationship Diagram
  D. Affinity Diagram
  A. QFD Matrix

• Question 293:

  The distance between the Mean of a data set and the Point of Inflection on a Normal curve is called the _______________.

  A. Curve Spread
  B. Standard Deviation
  C. Numerical Average
  D. Data Breadth
  B. Standard Deviation

• Question 294:

  Which of the following best describes internal failure costs?

  A. The economic costs associated with a catastrophic failure of an internal subsystem.
  B. The unavoidable quality system costs associated with the production of any product or service.
  C. The opposite of external failure costs.
  D. The costs resulting from a nonconformance detected before a product or service is provided
  D. The costs resulting from a nonconformance detected before a product or service is provided

• Question 295:

  One of the foundations of Lean Six Sigma is the concept that the output of a process (Y) is influenced by the process inputs (X's) and is commonly shown as which formula?

  A. Y = Z(X2)
  B. Y = f(X3)
  C. Y = f(Xn)
  D. Y = g(X+ 1.5)
  C. Y = f(Xn)

• Question 296:

  It would be more likely than not for a Belt conducting a RegressionAnalysis to find that the _______________________.

  A. r2 value is smaller than the absolute value of r
  B. Correlation Coefficient equals r2
  C. Coefficient of Determination is less than r2
  D. Correlation Coefficient equals r divided by 2
  A. r2 value is smaller than the absolute value of r

• Question 297:

  A team wants a technique for displaying the connection between various customer needs and various features on a product. They should use:

  A. written and diagrammed work instructions
  B. flow charts and process maps
  C. cause and effect diagrams
  D. Pareto chart
  E. relationship matrix
  E. relationship matrix

• Question 298:

  Which of these is not a primary cause for Non-normal Data?

  A. Skewness
  B. Mixed Distributions
  C. Kurtosis
  D. Formulosis
  E. Granularity
  D. Formulosis

• Question 299:

  Which statement(s) are correct about the DOE Factorial plot output here? (Note: There are 3 correct answers).

  

  A. Two factors were operated at 3 levels each
  B. The highest tool age was achieved with metal hardness at high level while keeping the cutting speed at the low level
  C. The design indicated above is a 32 factorial design
  D. The cutting speed and cutting angle are at the low level for the least tool age achieved
  E. All factors had 2 levels in the experiment
  B. The highest tool age was achieved with metal hardness at high level while keeping the cutting speed at the low level
  C. The design indicated above is a 32 factorial design
  E. All factors had 2 levels in the experiment

• Question 300:

  All of the following experimental designs could be used to investigate interactions EXCEPT

  A. half-fraction
  B. half-fraction with replication
  C. full-factorial with replication
  D. saturated screening with replication
  D. saturated screening with replication