NetApp Network Appliance NCIE-SAN NS0-504 Questions & Answers

• Question 31:

  How do you enable an FC port on a Cisco switch?

  A. no shutdown

  B. port enable on

  C. enable port on

  D. off shutdown

  Correct Answer: A

• Question 32:

  What is the storage system command line interface command fcp adapter show used to determine?

  A. if interlink Fibre Channel (FC) adapters are online

  B. it iSCSI host bus adapters (NBAs) are online

  C. if target Fibre Channel (FC) adapters are online

  D. if initiator Fibre Channel (FC) adapters are online

  Correct Answer: C

• Question 33:

  With Brocade FC switches, which commands will show you that the current configuration is supporting NPIV for the ports that are using it? (Choose three.)

  A. portcfgshow

  B. configshow

  C. switchshow

  D. cfgshow

  E. portshow

  F. showport

  Correct Answer: ADE

• Question 34:

  NetApp storage systems require which information to configure the storage system for management tools? (Choose two.)

  A. SnapMirror configuration information

  B. Configuration information for AutoSupport

  C. Volume options

  D. LUNs being used by clients

  E. IP addresses for e0M

  Correct Answer: BE

• Question 35:

  The storage administrator wants to ensure resilient non-interruptive access to a LUN in a cluster even if the volume containing the LUN is moved to any node within the cluster. What is the minimum recommended method to accomplish this requirement?

  A. Create a single fabric design with a single LIF on each node.

  B. Create a single fabric design with two LIFs on each node.

  C. Create a dual fabric design with a single LIF to one of the fabrics on each node.

  D. Create a dual fabric design with a single LIF to each of the fabrics on each node.

  Correct Answer: A

• Question 36:

  Which two must you specify when creating a volume? (Choose two.)

  A. snapshot reserve

  B. containing aggregate

  C. volume space guarantee

  D. containing Vserver

  E. junction path

  Correct Answer: AC

• Question 37:

  What does NetApp recommend as best practice for zone configuration?

  A. single port zoning

  B. single initiator zoning

  C. single target zoning

  D. multiple initiator zoning

  Correct Answer: B

• Question 38:

  What information do you NOT need to verify before ordering a NetApp storage solution?

  A. power sources and voltage available in Data Center

  B. A/C available in the Data Center

  C. raised floor in Data Center

  D. types of Ethernet switches for iSCSI traffic in Data Center

  Correct Answer: C

• Question 39:

  When Data ONTAP is running in Cluster-Mode, a portset contains an access list consisting of_________.

  A. physical nodes

  B. physical ports

  C. Logical interfaces (LIFs)

  D. LUNs

  Correct Answer: C

• Question 40:

  During a storage failover operation, paths to the down node will show as:

  A. Offline

  B. Unoptimized

  C. belonging to its HA partner

  D. Indirect

  Correct Answer: B