Cisco 640-692 Online Practice Questions and Exam Preparation

Cisco 640-692 Online Questions & Answers

• Question 11:

  Which of the following best describes how to assign a static IP address to the Ethernet port on a computer?

  A. From network Connections, click Create a New Connection and follow the network connection Wizard instructions.
  B. From Network Connections, double-click Local Area Connection. Click Protocol (TCP/IP). Click the properties, click the use the Following Address button, and then configure the IP information.
  C. Click Start> Run Enter cmd and click OK. Enter ip address XXX.XXX.XXX.XXX.
  D. From Network Connections, double-click Local Connection. Click Properties, click iPass Protocol (IEEE), click properties and select static IP.
  B. From Network Connections, double-click Local Area Connection. Click Protocol (TCP/IP). Click the properties, click the use the Following Address button, and then configure the IP information.

• Question 12:

  You are performing a password recovery on a Cisco fixed Catalyst switch. Click and drag the steps on the left into the correct order on the right.

  Select and Place:

  

  

• Question 13:

  When using a modem to provide out-of-band access to a Cisco router, which cable type is used to connect the wall jack to the modem?

  A. DB-25 to RJ-11
  B. RJ-11 to Rj-11
  C. RJ-45 to RJ-45
  D. RJ-11 to RJ-45
  E. RJ-11 to DB-9
  B. RJ-11 to Rj-11

• Question 14:

  Which three of the following statements are true about a smart jack? (Choose three)

  A. It provides signal conversion.
  B. It operates at Layer 2 of the OSI model.
  C. It regenerates the signal to compensate for signal degradation from line transmission.
  D. It provides loopback testing.
  E. It acts as a concentration point for dial-in and dial-out connections.
  A. It provides signal conversion.
  C. It regenerates the signal to compensate for signal degradation from line transmission.
  D. It provides loopback testing.

• Question 15:

  Refer to the exhibit.

  

  What does the CD LED indicate on the voice WAN interface card?

  A. An alarm condition
  B. Receive signal strength
  C. A carrier has been detected
  D. The interface is in loopback mode
  C. A carrier has been detected

• Question 16:

  What are two features that are associated with single-mode fiber-optic cable? (Choose two.)

  A. a single strand of glass fiber
  B. carries higher bandwidth than multimode fiber
  C. cost is less than multimode fiber
  D. operates over less distance than multimode fiber
  A. a single strand of glass fiber
  B. carries higher bandwidth than multimode fiber

• Question 17:

  A null modem cable uses which adapter type?

  A. RJ-11
  B. RJ-45
  C. RS-323
  D. RS-232
  E. USB
  B. RJ-45

• Question 18:

  ESD is the sudden and momentary electric current that flows between two different objects at different electrical potentials caused by direct contact or induced by an electrostatic field. Which three of the following tools should be used to avoid ESD? (Choose three)

  A. ESD wrist strap
  B. Latex gloves
  C. Antistatic bag
  D. Antistatic mat
  E. Negative static mat
  F. Negative static bag
  A. ESD wrist strap
  C. Antistatic bag
  D. Antistatic mat

• Question 19:

  Refer to the exhibit.

  

  Into which port do you insert the card?

  A. ATM
  B. Gigabit Ethernet
  C. Serial
  D. Ethernet
  B. Gigabit Ethernet

• Question 20:

  The colored wires at one end of the cable in the reverse sequence of the colored wires at the other end of the cable. Which cable does this describe?

  A. Rolled
  B. Coaxial
  C. Crossover
  D. Straight-through
  A. Rolled