Cisco 500-006 Online Practice Questions and Exam Preparation

Cisco 500-006 Online Questions & Answers

• Question 21:

  How can you independently restore the default links on a Cisco TelePresence VCS?

  A. with an xcommand from the API
  B. by performing a factory reset
  C. from the bandwidth configuration section of the web interface
  D. by performing a reboot
  A. with an xcommand from the API

• Question 22:

  Endpoints can be placed into different Cisco TelePresence VCS (X5 or above) subzones according to which of the following?

  A. aliases or IP addresses
  B. aliases and MAC addresses
  C. IP addresses only
  D. aliases, MAC addresses, and IP addresses
  A. aliases or IP addresses

• Question 23:

  What does it mean when an endpoint is Multiway-enabled?

  A. Endpoints can transfer calls from one endpoint to another.
  B. Endpoints can make simultaneous SIP and H.323 calls.
  C. Endpoints can deliver three or more streams of video.
  D. Endpoints can escalate calls to an MCU.
  D. Endpoints can escalate calls to an MCU.

• Question 24:

  The camera remote control is not responding. What can an engineer check in order to determine if the camera remote control or the system is causing the problem?

  A. The monitor is on the right channel.
  B. The switch inside the remote control is switched on.
  C. The light flashes on the camera when a key is pressed.
  D. The batteries are correctly placed within the remote.
  C. The light flashes on the camera when a key is pressed.

• Question 25:

  The following Cisco TMS warning is displayed. "No route possible between X and Y." What does this warning indicate?

  A. One of the endpoints is not registered on the Cisco TP VCS.
  B. There is a restriction that does not allow calls between zones.
  C. TMS cannot find one of the selected systems.
  D. Gateway is not available.
  B. There is a restriction that does not allow calls between zones.

• Question 26:

  All Cisco TMS users and administrators are members of which default group?

  A. users
  B. video unit administrator
  C. site administrator
  D. administrator
  A. users

• Question 27:

  If provisioning replication fails for any reason, what should be done to determine the cause of the failure?

  A. Re-install the Cisco Jabber Video client and try again.
  B. Run all diagnostic tests on the TMS PE Diagnostics page.
  C. Capture Cisco TelePresence Jabber Video logs and find the problem.
  D. Run a Wireshark trace on the communication between the Cisco Jabber Video client and the Cisco VCS.
  B. Run all diagnostic tests on the TMS PE Diagnostics page.

• Question 28:

  In the Cisco TelePresence Conductor web pages, which logs can you view?

  A. system log, event log, and CDR log
  B. system log and event log
  C. event log and configuration log
  D. system log, event log, configuration log, and CDR log
  C. event log and configuration log

• Question 29:

  Which Cisco TelePresence C Series Codec command will move the on-screen display to monitor output 4?

  A. configuration video osd output: 4
  B. xconfiguration video osd output: 4
  C. command video osd output: 4
  D. xcommand video osd output: 4
  B. xconfiguration video osd output: 4

• Question 30:

  Which user groups on the Cisco TelePresence VCS are available for LDAP integration?

  A. administration and FindMeTM users
  B. administration and supervisor users
  C. supervisor users and client users
  D. client users and FindMe users
  A. administration and FindMeTM users