Cisco 350-020 Online Practice Questions and Exam Preparation

Cisco 350-020 Online Questions & Answers

• Question 131:

  Which are the correct ways to release IBGP from the condition that all IBGP neighbors need to be fully meshed? (multiple answer)

  A. Configure local preference
  B. Configure route reflectors
  C. Configure IBGP neighbors several hops away
  D. Configure confederations
  B. Configure route reflectors
  D. Configure confederations

• Question 132:

  Within a SONET frame, what does NOT have a fixed position?

  A. Section Overhead
  B. Path Overhead
  C. Line Overhead
  D. Transport Overhead
  E. Multiplex Section Overhead
  B. Path Overhead

• Question 133:

  When an ML-series RPR ring is provisioned over a SONET BLSR (or SDH MS-SPR) ring, the ML architecture can no longer utilize the full available bandwidth on the SONET/SDH ring due to the constraints of BLSR. Which features are being introduced to allow use of discontiguous timeslots and BLSR protect channels when provisioning ML-series RPR rings, in order to alleviate this limitation?

  A. Software Link Capacity Adjustment Scheme (SW-LCAS)
  B. Low Order Virtual Concatenation (LO-VCAT)
  C. Framed Generic Framing Procedure (GFP-F)
  D. High Order Virtual Concatenation (HO-VCAT)
  E. Bridge Control Protocol (BCP)
  A. Software Link Capacity Adjustment Scheme (SW-LCAS)
  D. High Order Virtual Concatenation (HO-VCAT)

• Question 134:

  You have an E-series shared packet ring of size STS-3c consisting of ONS 15454 nodes. What is the maximum size point-to-point circuit that can be configured with the remaining bandwidth to the multi-card Ethernet group on the E-series cards?

  A. STS-1
  B. STS-3C
  C. STS-6C
  D. STS-12C
  E. STS-24C
  B. STS-3C

• Question 135:

  What is the transmission limitation on a single 1310 nm signal, at OC-192 bit-rate, over certified SMF. 28 fiber using no dispersion compensation?

  A. Four-wave mixing
  B. Polarization-mode dispersion
  C. Chromatic dispersion
  D. Attenuation
  D. Attenuation

• Question 136:

  A network operator wants to have a continuous view of network alarms as they occur. What CTM component

  A. CTM Dashboard
  B. Domain Explorer
  C. NE Explorer
  D. Subnetwork Explorer
  A. CTM Dashboard

• Question 137:

  What describes a technique, used to encapsulate voice (NOT data) over ATM?

  A. RFC 1483
  B. lane
  C. AAL-1
  D. RFC 1577
  C. AAL-1

• Question 138:

  CIDR is primarily used:

  A. In BGP only
  B. For classless routing
  C. In OSPF only
  D. In EIGRP only
  B. For classless routing

• Question 139:

  Click the Exhibit button.

  

  The exhibit represents a power to frequency graph of a modulated optical signal with a base side of the base frequency represent?

  A. Pink noise of the transmitter
  B. Four-wave mixing products
  C. Modulation sidebands of the optical signal
  D. Other wavelengths in a DWDM system
  E. Gain tilt of wavelengths in a DWDM system
  C. Modulation sidebands of the optical signal

• Question 140:

  What is NOT an ATM class of service?

  A. CBR
  B. VBR-t
  C. ABR
  D. UBR
  E. CAR
  E. CAR