1. Home
  2. Cisco
  3. 300-410

Cisco 300-410 Online Practice Questions and Exam Preparation

300-410 Exam Details

  • Exam Code
    :300-410
  • Exam Name
    :Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)
  • Certification
    :CCNP Enterprise
  • Vendor
    :Cisco
  • Total Questions
    :955 Q&As
  • Last Updated
    :Jun 02, 2026

Cisco 300-410 Online Questions & Answers

  • Question 511:

    Refer to the exhibit. A network is configured for EIGRP equal-cost load balancing, but the traffic destined to the servers is not load balanced. Link metrics from router R2 to R3 and R4 are the same. Which delay value must be configured to resolve the issue?

    A. 2200 on R4 E0/1
    B. 200 on R3 E0/1
    C. 120 on R3 E0/1
    D. 120 on R4 E0/1

  • Question 512:

    DRAG DROP

    Drag and drop the descriptions from the left onto the corresponding MPLS components on the right.

    Select and Place:

  • Question 513:

    The network team is reviewing its options with regard to network address translation. Now that the network has been completely changed over to IPv6, you need a mechanism to translate from the private IPv6 addresses inside your network to public IPv6 addresses. You would like for these mappings to be one-to-one.

    Which of the following performs this function?

    A. stateful NAT64
    B. NPT6
    C. NAT44
    D. stateless NAT 64

  • Question 514:

    Which command can you use to specify that network 208.15.208.0 belongs to OSPF area 0?

    A. router(config)# network 208.15.208.0 area 0
    B. router(config-if)# ip ospf area 0
    C. router(config)# network 208.15.208.0 255.255.255.0 area 0
    D. router(config-router)# network 208.15.208.0 0.0.0.255 area 0

  • Question 515:

    Refer to the exhibit.

    The engineer is reviewing the logs on the DENVER router and notices that this error message repeats constantly: *Jun 12 13:42:03.399: %TCP-6-BADAUTH: No MD5 digest from 10.40.1.1(27174) to 10.40.1.2(179) tableid - 0 Which action resolves the issue?

    A. Configure OSPF link authentication on the router with IP address 10.40.1.1.
    B. Configure NTP authentication on the router with IP address 10.40.1.1.
    C. Configure BGP authentication on the router with IP address 10.40.1.2.
    D. Configure BGP authentication on the router with IP address 10.40.1.1.

  • Question 516:

    An administrator attempts to download the pack NBAR2 file using TFTP from the CPE router to another device over the Gi0/0 interface. The CPE is configured as below: The transfer fails. Which action resolves the issue?

    A. Change the WAN ACL to permit the UDP port 69 to allow TFTP
    B. Make the permit udp any eq tftp any entry the last entry in the WAN ACL.
    C. Change the WAN ACL to permit the entire UDP destination port range
    D. Shorten the file name to the 8+3 naming convention.

  • Question 517:

    Refer to the exhibit.

    The 130.130.130.0/24 route shows in the R2 routing table but is getting filtering toward R3.

    Which action resolves the issue?

    A. Automatic route summarization must be enabled on R2.
    B. The outgoing filter list for all interfaces must be set on R2.
    C. The incoming filter list for all interfaces must be set on R2.
    D. IGP synchronization must be disabled on R2.

  • Question 518:

    Which Cisco VPN technology can use multipoint tunnel, resulting in a single GRE tunnel interface on the hub, to support multiple connections from multiple spoke devices?

    A. DMVPN
    B. GETVPN
    C. Cisco Easy VPN
    D. FlexVPN

  • Question 519:

    Refer to the exhibit.

    After reloading the router, an administrator discovered that the interface utilization graphs displayed inconsistencies with their previous history in the NMS. Which action prevents this issue from occurring after another router reload in the future?

    A. Configure SNMP interface index persistence on the router.
    B. Save the router configuration to startup-config before reloading the router.
    C. Rediscover all the router interfaces through SNMP after the router is reloaded.
    D. Configure SNMP to use static OIDs referring to individual router interfaces.

  • Question 520:

    Refer to the exhibit.

    An engineer configured NetFlow to capture traffic information through the router, but it iOS not working as expected. Which action captures the flow information from this router to the collector?

    A. Change the interface configuration FLOW-MONITOR-1 from input to output.
    B. Configure a flow exporter under flow FLOW-MONITOR-1.
    C. Configure more than one flow exporter destination addresses.
    D. Change the flow exporter transport protocol from UDP to TCP

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Cisco exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 300-410 exam preparations and Cisco certification application, do not hesitate to visit our Vcedump.com to find your solutions here.