Cisco 300-320 Online Practice Questions and Exam Preparation

Cisco 300-320 Online Questions & Answers

• Question 111:

  Which OSPF option can you configure to connect two parts of a partitioned backbone through a nonbackbone area?

  A. route summarization
  B. a virtual link
  C. an NSSA
  D. a static OSPF neighbor
  B. a virtual link

• Question 112:

  If your enterprise is connected to 2 ISP, which method could you use to prevent being used as a transit network? (Choose Two)

  A. filter outbound
  B. filter inbound
  C. throw both ISP
  D. choose only one ISP
  E. Allow every routes inbound
  A. filter outbound
  E. Allow every routes inbound

  ---

  https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/23675-27.html

• Question 113:

  Which two options are two benefits of a Layer 2 looped model? (Choose two.)

  A. extends VLANs between switches that are connected to a common aggregation module
  B. prevents uplink ports from entering the spanning-tree blocking state
  C. provides quick convergence with Rapid Spanning Tree Protocol
  D. increases performance to end hosts using directly connected, bonded Layer 2 links
  A. extends VLANs between switches that are connected to a common aggregation module
  C. provides quick convergence with Rapid Spanning Tree Protocol

• Question 114:

  Which statement best describes Cisco OTV internal interfaces?

  A. They are Layer 2 interfaces that are configured as either access or trunk interfaces on the switch.
  B. They are interfaces that perform Layer 3 forwarding with aggregation switches.
  C. They are the interfaces that connect to the ISP.
  D. They are tunnel interfaces that are configured with GRE encapsulation.
  A. They are Layer 2 interfaces that are configured as either access or trunk interfaces on the switch.

  ---

  https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Data_Center/DCI/whitepaper/DCI3_OTV_Intro/DCI_1.html "Internal Interfaces To perform OTV functionality, the edge device must receive the Layer 2 traffic for all VLANs that need to be extended to remote locations. The Layer 2 interfaces, where the Layer 2 traffic is usually received, are named internal interfaces"

• Question 115:

  Refer to the exhibit. Which option should be the default gateway for the PC1 that is shown?

  

  A. 10.3.2.4
  B. 10.2.2.2
  C. 10.2.2.1
  D. 10.2.2.3
  A. 10.3.2.4

• Question 116:

  For which engine an IPS can use its reputation awareness? (Choose two)

  A. Reputation filtering
  B. Reputation subscriptions
  C. Correlation rules
  D. Global correlation inspection
  A. Reputation filtering
  C. Correlation rules

  ---

  http://www.cisco.com/c/en/us/products/collateral/security/ips-4500-series-sensors/white_paper_c11-715386.html

• Question 117:

  Multipath to two datacenter by L2 networks overlap addresses and must be work (2 answers)

  A. vxlan
  B. OTV
  C. VRF
  D. vpn
  E. HSRP
  A. vxlan
  B. OTV

• Question 118:

  Company has asked for an OOB management network design.

  Which option is one Cisco best practice parameter that must be followed?

  A. Data networks must be limited to SSH, NTP, FTP, SNMP and TaCACS+ protocols
  B. Data networks must never traverse the management network
  C. Data networks and management networks must be in the routing table
  D. Data networks must traverse the management network as a backup path
  B. Data networks must never traverse the management network

• Question 119:

  What SAN technology can accomplish fabric infrastructure implementation using multiple fabrics?

  A. VSAN
  B. IVR
  C. SCSI
  D. NAS
  A. VSAN

• Question 120:

  Recently, the WAN links between the headquarters and branch offices have been slow under peak congestion, yet multiple alternate WAN paths exist that are not always congested. What technology can allow traffic to be routed in a more informed manner to utilize transport characteristics such as delay, loss, or link load?

  A. performance routing
  B. static routing
  C. on demand routing
  D. policy based routing
  A. performance routing