VMware 2V0-641 Online Practice Questions and Exam Preparation

VMware 2V0-641 Online Questions & Answers

• Question 91:

  What is the earliest version of vCloud Network and Security (vCNS) that can be upgraded to VMware NSX for vSphere 6.0?

  A. vCNS 5.0
  B. vCNS 5.1
  C. vCNS 5.5
  D. vCNS 6.0
  C. vCNS 5.5

• Question 92:

  -- Exhibit -

  

  -- Exhibit -An administrator is troubleshooting a NSX controller cluster issue and runs the control-cluster command, as shown in the Exhibit.

  What information can be determined from the output provided in the exhibit?

  A. This is the control cluster majority leader controller.
  B. There are two controllers in the cluster.
  C. This is not the control cluster majority leader controller.
  D. The persistence_server role is not functioning correctly.
  C. This is not the control cluster majority leader controller.

• Question 93:

  An administrator has deployed NSX in an environment containing a mix of vSphere 5 hosts. The implementation includes the Distributed Firewall Service, but the administrator finds that rules are not being applied to all affected virtual machines.

  What two conditions would cause this behavior? (Choose two.)

  A. Some hosts have not been prepared for NSX.
  B. Only ESXi 5.5 and later hosts can push the rules to the virtual machines.
  C. Only ESXi 5.1 and later hosts can push the rules to the virtual machines.
  D. Some hosts are blocking the port used for rule distribution.
  A. Some hosts have not been prepared for NSX.
  C. Only ESXi 5.1 and later hosts can push the rules to the virtual machines.

• Question 94:

  -- Exhibit -

  

  -- Exhibit -An administrator has created the NSX network shown in the exhibit.

  Both VMs use the same Distributed Router for their default gateway. VM-B receives an IP message from VM-A.

  What is the source MAC address of the IP message received by VM-B?

  A. VM-A's MAC address.
  B. VM-B's default gateway's MAC Address.
  C. VM-A's default gateway's MAC address.
  D. Logical Switch 7321's MAC address
  A. VM-A's MAC address.

• Question 95:

  -- Exhibit -

  

  -- Exhibit -An NSX administrator is examining an error in the Event Console as shown in the Exhibit.

  Which condition would result in this error?

  A. The configured MTU size on the physical network is too small.
  B. The VTEP IP pool addresses are on the ESXi management network subnet.
  C. VLANs are configured on the logical network.
  D. A VXLAN segment ID pool is not configured.
  B. The VTEP IP pool addresses are on the ESXi management network subnet.

• Question 96:

  A vSphere administrator deploys the NSX Edge Load Balancer in Inline mode. Which is not a requirement for the Load Balancer to operate correctly?

  A. Perform Source NAT on the traffic from the clients.
  B. Connect the Load Balancer directly to the same subnet as the VMs that are part of the Server Pool.
  C. Perform Destination NAT on the traffic from the clients.
  D. Point the virtual machines in the Server Pool to the Load Balancer as their default gateway.
  A. Perform Source NAT on the traffic from the clients.

• Question 97:

  You are tasked with designing a data center architecture that should maximize the use of vMotion within your environment. The design has these requirements:

  

  The network must utilize widely offered layer 2 switching and layer 3 switching services

  

  Purchase of new equipment should be minimized

  Which two network design architectures will provide the requirements for vMotion in your data center? (Choose two.)

  A. Utilize layer 3 switching from the access layer through the core.
  B. Employ layer 2 multipathing using a standardized protocol.
  C. Deploy a flat, traditional layer 2 switched network.
  D. Deploy an overlay technology for the deployment of your virtual network.
  A. Utilize layer 3 switching from the access layer through the core.
  D. Deploy an overlay technology for the deployment of your virtual network.

• Question 98:

  Which two statements are true regarding NSX? (Choose two.)

  A. Workloads can be placed and moved independently of physical topology.
  B. Operational efficiency can be achieved through automation of the physical network.
  C. Workload deployments are non-disruptive over the existing physical network.
  D. NSX implementation requires a VMware vSphere environment.
  A. Workloads can be placed and moved independently of physical topology.
  C. Workload deployments are non-disruptive over the existing physical network.

• Question 99:

  Which component provides for installation of NSX hypervisor kernel components and user world agents?

  A. NSX Controller
  B. NSX Edge Virtual Appliance
  C. NSX Manager
  D. vRealize Automation
  C. NSX Manager

• Question 100:

  Which two NSX Data Security roles could be assigned to view configured policies and violation reports? (Choose two.)

  A. Security Administrator
  B. NSX Administrator
  C. Auditor
  D. Enterprise Administrator
  A. Security Administrator
  C. Auditor