1. Home
  2. VMware
  3. 2V0-620

VMware 2V0-620 Online Practice Questions and Exam Preparation

2V0-620 Exam Details

  • Exam Code
    :2V0-620
  • Exam Name
    :vSphere 6 Foundations Beta
  • Certification
    :VMware Certifications
  • Vendor
    :VMware
  • Total Questions
    :191 Q&As
  • Last Updated
    :Dec 18, 2024

VMware 2V0-620 Online Questions & Answers

  • Question 1:

    Which three VLAN Tagging modes are available in vSphere 6.x? (Choose three.)

    A. External Switch Tagging
    B. Private VLAN Tagging
    C. Virtual Switch Tagging
    D. VXLAN Tagging
    E. Virtual Guest Tagging

  • Question 2:

    A virtual machine is experiencing performance issues. The following performance metrics are observed:

    CPU usage value for the virtual machine is above 90%

    CPU ready value for the virtual machine is above 20%

    Which two activities will likely resolve the performance issues? (Choose two.)

    A. Set a CPU reservation for the virtual machine.
    B. Increase the CPU limit on the virtual machine.
    C. Decrease CPU shares equally for all virtual machines on the host.
    D. Increase CPU shares equally for all virtual machines on the host.

  • Question 3:

    An administrator has been tasked with enabling High Availability (HA) on a cluster in a vSphere 6.x environment with default settings. The cluster configures properly and there are no errors. The next day when powering on a virtual machine,

    an error is presented:

    Not Enough Failover Resources

    Which three scenarios are likely causes of this error message? (Choose three.)

    A. The default VM Monitoring Sensitivity is set too high.
    B. There are not enough datastore heartbeat datastores configured by default.
    C. The default slot size in the cluster is set too high.
    D. There are virtual machines with large CPU reservations.
    E. A host is in maintenance mode for a replacement of a failed Hard Drive.

  • Question 4:

    Refer to the Exhibit.

    An administrator is viewing network connectivity for a new virtual machine, as shown in the Exhibit.

    Based on the Exhibit, what will occur with the network traffic of this virtual machine when communicating externally from vSwitch1?

    A. The virtual machine will communicate on both uplinks
    B. The virtual machine will only communicate on vmnic1
    C. The virtual machine will only communicate on vmnic2
    D. The virtual machine will fail to communicate externally

  • Question 5:

    Refer to the Exhibit.

    An administrator has created the resource pool configuration shown in the Exhibit. Based on the exhibit, which virtual machine(s) can be successfully powered on?

    A. VM-M1 only
    B. VM-K1 only
    C. VM-K1 and VM-K2 only
    D. VM-K1, VM-K2, and VM-M1

  • Question 6:

    In order for a company to meet regulatory requirements, all ESXi 6.x Hosts must be configured to direct logs to a syslog server. What are two ways ESXi hosts can configured for this action? (Choose two)

    A. Use the esxcli system syslog command.
    B. Edit them in the ESXi host Advanced System Settings.
    C. From the Syslog collector user interface of the Web Client.
    D. Syslog logging is not available for ESXi Hosts.

  • Question 7:

    What are two benefits of using NFS 4.1 with vSphere 6.x as compared to NFS 3? (Choose two.)

    A. NFS 4.1 supports Kerberos Authentication
    B. NFS 4.1 supports multipathing
    C. NFS 4.1 supports IPv6
    D. NFS 4.1 supports hardware acceleration

  • Question 8:

    An administrator has just configured the IP address on an ESXi host from the Direct Console User Interface.

    How can the configuration be validated as correct without any additional tools?

    A. Add the host to vCenter Server and if it works, then all networking settings are ok.
    B. Select the Test Management Network option from the DCUI.
    C. Connect to the host with the vSphere Client and click the Test Network option.
    D. Use PowerCLI to connect to the host and initiate a network test.

  • Question 9:

    An administrator is monitoring a fully automated vSphere cluster configured with HA, DRS, DPM and EVC. The administrator notices that the cluster has a greater than expected load imbalance. Why is this happening?

    A. The DRS Migration Threshold is not aggressive enough.
    B. The EVC baseline is masking too many CPU features.
    C. The HA VM Restart Priority is set too high for several virtual machines.
    D. The DPM Threshold is not aggressive enough.

  • Question 10:

    An administrator is troubleshooting basic network connectivity issues.

    Which two scenarios are potential issues that this administrator might face? (Choose two.)

    A. The vSwitch is not attached to the correct physical network.
    B. The portgroup is not configured to use correct VLAN.
    C. Traffic shaping is configured incorrectly.
    D. Jumbo frames is configured incorrectly.

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only VMware exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 2V0-620 exam preparations and VMware certification application, do not hesitate to visit our Vcedump.com to find your solutions here.