Cisco 200-310 Online Practice Questions and Exam Preparation

Cisco 200-310 Online Questions & Answers

• Question 381:

  Which option is one of the methods that Cisco routers and switches can use to share information between directly connected devices on a regular basis?

  A. NetFlow
  B. ARP
  C. NHRP
  D. CDP
  D. CDP

• Question 382:

  Refer to the exhibit. Which action can be taken in this network design to make it more resilient?

  

  A. Add carrier redundancy
  B. Add additional Layer 2 trunks between core/distribution switches
  C. Add additional Layer 2 trunks between access switches
  D. Extend Layer 3 connectivity to access layer using dynamic routing protocol
  A. Add carrier redundancy

• Question 383:

  In an enterprise Layer 2 switched network, which protocol must be running to enable link redundancy?

  A. CDP
  B. STP
  C. LACP
  D. PAGP
  B. STP

• Question 384:

  What tool would you use to capture, segregate and analyse IP traffic?

  A. Protocol Analyser
  B. NetFlow
  B. NetFlow

• Question 385:

  Refer to the exhibit.

  

  Based on the following output from the access switch, which option is the trust boundary for QoS?

  

  A. IP phone
  B. access
  C. core
  D. endpoint
  E. distribution
  B. access

• Question 386:

  A network engineer must connect two sites. Each site has a different autonomous system number. Which method do you use to exchange routing information between the sites?

  A. OSPFv3
  B. IGP
  C. EIGRP
  D. BGP
  D. BGP

• Question 387:

  What are two components of the Build phase in the Cisco Design Lifecycle? (Choose two.)

  A. Migration
  B. Deployment
  C. Optimization
  D. Design
  E. Configuration
  A. Migration
  B. Deployment

• Question 388:

  Which one of these statements is true concerning the data center distribution (aggregation) layer design?

  A. With Layer 3 at the aggregation layer, the physical loops in the topology must still be managed by STP.
  B. The boundary between Layer 2 and Layer 3 must reside in the multilayer switches, independent of any other devices such as firewalls or content switching devices.
  C. A mix of both Layer 2 and Layer 3 access is sometimes the most optimal.
  D. In a small data center, the aggregation layer can connect directly to the campus core, exchanging IP routes and MAC address tables.
  C. A mix of both Layer 2 and Layer 3 access is sometimes the most optimal.

• Question 389:

  You are designing a network that will support the addition of bandwidth as demand increases. Which term correctly describes this requirement?

  A. resiliency
  B. scalability
  C. modularity
  D. multitiered
  B. scalability

• Question 390:

  Your supervisor has asked you to deploy a routing protocol within the lab environment that will allow for unequal cost multipath routing. Which should you choose?

  A. EIGRP
  B. OSPF
  C. IS-IS
  D. RIP
  A. EIGRP