CheckPoint 156-915.80 Online Practice Questions and Exam Preparation

CheckPoint 156-915.80 Online Questions & Answers

• Question 521:

  MicroCorp experienced a security appliance failure. (LEDs of all NICs are off.) The age of the unit required that the RMA-unit be a different model. Will a revert to an existing snapshot bring the new unit up and running?

  A. There is no dynamic update at reboot.
  B. No. The revert will most probably not match to hard disk.
  C. Yes. Everything is dynamically updated at reboot.
  D. No. At installation the necessary hardware support is selected. The snapshot saves this state.
  D. No. At installation the necessary hardware support is selected. The snapshot saves this state.

• Question 522:

  Advanced Security Checkups can be easily conducted within:

  A. Reports
  B. Advanced
  C. Checkups
  D. Views
  A. Reports

• Question 523:

  You need to see which hotfixes are installed on your gateway, which command would you use?

  A. cpinfo –h all
  B. cpinfo –o hotfix
  C. cpinfo –l hotfix
  D. cpinfo –y all
  D. cpinfo –y all

• Question 524:

  Which view is NOT a valid CPVIEW view?

  A. IDA
  B. DLP
  C. PDP
  D. VPN
  C. PDP

• Question 525:

  What is mandatory for ClusterXL to work properly?

  A. The number of cores must be the same on every participating cluster node
  B. The Magic MAC number must be unique per cluster node.
  C. The Sync Interface must not have an IP address configured
  D. If you have "Non-monitored Private" interfaces, the number of those interfaces must be the same on all cluster members
  B. The Magic MAC number must be unique per cluster node.

• Question 526:

  Type the command and syntax to view critical devices on a cluster member in a ClusterXL environment.

  cphaprob -ia list

• Question 527:

  Which packet info is ignored with Session Rate Acceleration?

  A. source port ranges
  B. source ip
  C. source port
  D. same info from Packet Acceleration is used
  C. source port

• Question 528:

  If the first packet of an UDP session is rejected by a security policy, what does the firewall send to the client?

  A. Nothing
  B. TCP FIN
  C. TCP RST
  D. ICMP unreachable
  A. Nothing

• Question 529:

  SmartEvent provides a convenient way to run common command line executables that can assist in investigating events. Right-clicking the IP address, source or destination, in a event provides a list of default and customized commands. They appear only on cells that refer to IP addresses because the IP address of the active cell is used as the destination of the command when run. The default commands are:

  A. ping, traceroute, netstat, and route
  B. ping, nslookup, Telnet, and route
  C. ping, whois, nslookup, and Telnet
  D. ping, traceroute, netstat, and nslookup
  C. ping, whois, nslookup, and Telnet

• Question 530:

  Which command will reset the kernel debug options to default settings?

  A. fw ctl dbg -a 0
  B. fw ctl dbg resetall
  C. fw ctl debug 0
  D. fw ctl debug set 0
  C. fw ctl debug 0