Lpi 117-101 Online Practice Questions and Exam Preparation

Lpi 117-101 Online Questions & Answers

• Question 101:

  ________ /dev/sda3 will create a swap area on the device/dev/sda3.

  mkswap

  -or- /sbin/mkswap

• Question 102:

  The _____________ command displays ISA plug-and-play devices resource information.

  pnpdump

• Question 103:

  The lspci command can display information about devices except the following:

  A. Card bus speed (e.g. 66Mhz)
  B. Card IRQ settings
  C. Card vendor identification
  D. Card AGP rate (e.g. 1x, 2x, 4x)
  E. Card Ethernet MAC address
  E. Card Ethernet MAC address

• Question 104:

  Which system administration command you can use to update ld.so.cache after the installation of new shared libraries?

  A. ldconfig
  B. ldd
  C. libpath
  D. newlibs
  A. ldconfig

• Question 105:

  You have not run apt-get on a system for some time, but it has been run on the system before. What apt- get command would you run to download the latest list of packages, but not the packages themselves?

  A. apt-get build-dep
  B. apt-get mirror-select
  C. apt-get update
  D. apt-get upgrade
  E. apt-get dist-upgrade
  C. apt-get update

• Question 106:

  You have just upgraded your PC to a 60 gigabyte IDE drive. While partitioning the drive, you notice that only 32 gigabytes are available. Which of the following will most likely allow you to use the entire drive?

  A. Create two smaller partitions of 30 gigabytes each.
  B. Set the PC BIOS to use LBA mode.
  C. Create a partition that resides entirely below the first 1024 cylinders.
  D. Use GRUB or the latest version of LILO as a bootloader.
  E. Upgrade the PC BIOS to the latest version available.
  E. Upgrade the PC BIOS to the latest version available.

• Question 107:

  You want to save vi changes to the file myfile with :w!, but vi complains it can not write to the file. Therefore, you want to check the write permissions on the file. To do this without leaving vi, you type:

  A. :!ls -l myfile
  B. :\ls -l myfile
  C. esc :ls -l myfile
  D. :?ls -l myfile
  A. :!ls -l myfile

• Question 108:

  What command will uninstall a package but leave its configuration files in case a package is re-installed?

  A. none, no command will do this
  B. dpkg -s pkgname
  C. dpkg -L pkgname
  D. dpkg -P pkgname
  E. dpkg -r pkgname
  E. dpkg -r pkgname

• Question 109:

  How can you update a package only if an earlier version is currently installed on the system?

  A. rmp -- update rpmname
  B. rpm -U rpmname
  C. rpm -F rpmname
  D. rpm -- force rpmname
  E. rpm -u rpmname
  C. rpm -F rpmname

• Question 110:

  What command would help you identify the I/O address range being used by the network card?

  A. cat/proc/modules
  B. cat/proc/devices
  C. cat/proc/meminfo
  D. cat/io/dma
  E. cat/proc/ioports
  E. cat/proc/ioports