NSE7_EFW-7.0 Web TestEngine Demo

Q24 Single choice

View the exhibit, which contains a screenshot of some phase-1 settings, and then answer the question below.

The VPN is up, and DPD packets are being exchanged between both IPsec gateways; however, traffic
cannot pass through the tunnel. To diagnose, the administrator enters these CLI commands:

However, the IKE real time debug does not show any output.

Why?

A
The debug output shows phases 1 and 2 negotiations only. Once the tunnel is up, it does not show any more output.
B
The log-filter setting was set incorrectly. The VPN's traffic does not match this filter.
C
The debug shows only error messages. If there is no output, then the tunnel is operating normally.
D
The debug output shows phase 1 negotiation only. After that, the administrator must enable the
following real time debug: diagnose debug application ipsec -1.

NSE7_EFW-7.0 Web TestEngine demo