Free H12-891 Web TestEngine Demo

Q28 Single choice

The router connects two EBGP neighbors through two parallel Serial cables.

What should you do to achieve bidirectional load sharing between the two EBGP neighbors connected by these parallel Serial cables?

A
No configuration is required; BGP automatically implements load sharing of traffic across different
autonomous systems on available links
B
Use the Loopback interface to establish an EBGP neighbor relationship, configure EBGP multi-hop, configure the Loopback interface as the update source, and then use IGP to implement equal-cost path
load sharing between Loopback addresses
C
Configure the EBGP neighbor relationship with the Loopback interface as the update source; the IGP in
each AS must introduce two equal-cost paths to the EBGP neighbor's Loopback address, and the command "next-hop-local" must be used
D
Use the command "ebgp-load-balance" at both ends
E
Configure the EBGP neighbor relationship with the Loopback interface as the update source; the IGP in
each AS must introduce two equal-cost paths to the EBGP neighbor's Loopback address, and use the commands "ebgp max-hop" and "next-hop-local"

H12-891 Web TestEngine demo