FCSS_NST_SE-7.6 Web TestEngine Demo

Q16 Single choice

Refer to the exhibit.

Which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

Diagnose vpn ike log-filter dst-addr4 10.0.10.1
Diagnose debug application ike -1 However, the IKE real-time debug does not show any output.

Why?

A
The administrator must also run the command diagnose debug enable.
B
The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.
C
The log-filter setting is incorrect. The VPN traffic does not match this filter.
D
Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

FCSS_NST_SE-7.6 Web TestEngine demo