Exam Details

  • Exam Code
    :NSE4-5.4
  • Exam Name
    :Fortinet Network Security Expert 4 Written Exam - FortiOS 5.4
  • Certification
    :Fortinet Certifications
  • Vendor
    :Fortinet
  • Total Questions
    :576 Q&As
  • Last Updated
    :Dec 30, 2024

Fortinet Fortinet Certifications NSE4-5.4 Questions & Answers

  • Question 141:

    Review the IPS sensor filter configuration shown in the exhibit

    Based on the information in the exhibit, which statements are correct regarding the filter? (Choose two.)

    A. It does not log attacks targeting Linux servers.

    B. It matches all traffic to Linux servers.

    C. Its action will block traffic matching these signatures.

    D. It only takes effect when the sensor is applied to a policy.

  • Question 142:

    Examine the following log message for IPS and identify the valid responses below. (Select all that apply.)

    A. The target is 192.168.3.168.

    B. The target is 192.168.3.170.

    C. The attack was detected and blocked.

    D. The attack was detected only.

    E. The attack was TCP based.

  • Question 143:

    Which IPsec mode includes the peer id information in the first packet?

    A. Main mode.

    B. Quick mode.

    C. Aggressive mode.

    D. IKEv2 mode.

  • Question 144:

    Which statements are correct properties of a partial mesh VPN deployment. (Choose two.)

    A. VPN tunnels interconnect between every single location.

    B. VPN tunnels are not configured between every single location.

    C. Some locations are reached via a hub location.

    D. There are no hub locations in a partial mesh.

  • Question 145:

    Review the configuration for FortiClient IPsec shown in the exhibit.

    Which statement is correct regarding this configuration?

    A. The connecting VPN client will install a route to a destination corresponding to the student_internal address object.

    B. The connecting VPN client will install a default route.

    C. The connecting VPN client will install a route to the 172.20.1.[1-5] address range.

    D. The connecting VPN client will connect in web portal mode and no route will be installed.

  • Question 146:

    Review the IPsec phase 1 configuration in the exhibit; then answer the question below.

    Which statements are correct regarding this configuration? (Choose two.)

    A. The remote gateway address on 10.200.3.1.

    B. The local IPsec interface address is 10.200.3.1.

    C. The local gateway IP is the address assigned to port1.

    D. The local gateway IP address is 10.200.3.1.

  • Question 147:

    Review the IPsec diagnostics output of the command diagnose vpn tunnel list shown in the exhibit below.

    Which statements are correct regarding this output? (Choose two.)

    A. The connecting client has been allocated address 172.20.1.1.

    B. In the Phase 1 settings, dead peer detection is enabled.

    C. The tunnel is idle.

    D. The connecting client has been allocated address 10.200.3.1.

  • Question 148:

    Review the IKE debug output for IPsec shown in the exhibit below.

    Which statements is correct regarding this output?

    A. The output is a phase 1 negotiation.

    B. The output is a phase 2 negotiation.

    C. The output captures the dead peer detection messages.

    D. The output captures the dead gateway detection packets.

  • Question 149:

    Which statement is an advantage of using a hub and spoke IPsec VPN configuration instead of a fully-meshed set of IPsec tunnels?

    A. Using a hub and spoke topology provides full redundancy.

    B. Using a hub and spoke topology requires fewer tunnels.

    C. Using a hub and spoke topology uses stronger encryption protocols.

    D. Using a hub and spoke topology requires more routes.

  • Question 150:

    Review the IPsec phase 2 configuration shown in the exhibit; then answer the question below.

    Which statements are correct regarding this configuration? (Choose two.).

    A. The Phase 2 will re-key even if there is no traffic.

    B. There will be a DH exchange for each re-key.

    C. The sequence number of ESP packets received from the peer will not be checked.

    D. Quick mode selectors will default to those used in the firewall policy.

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Fortinet exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your NSE4-5.4 exam preparations and Fortinet certification application, do not hesitate to visit our Vcedump.com to find your solutions here.