What VSX components do not support IPv6 in R77 VSX mode?
A. VSX mode does not support IPv6
B. All devices support IPv6
C. Virtual Systems
D. Virtual Routers
A system administrator wants to convert an IPv6 gateway from a standard gateway into a gateway running VSX mode. What does he need to consider?
A. It is not possible to convert a gateway with IPv6 enabled to VSX mode.
B. There needs to be proper IPv6 routing setup.
C. At least two interfaces need to be configured with IPv6.
D. Policy needs to be properly applied to the gateway before converting the system to VSX mode.
What command allows you to monitor IPV6 packets in the kernel module?
A. ip -6 neigh show
B. ip -6 addr show
C. tcpdump -nni eth
D. fw6 monitor
True or False: It is possible to operate a Security Gateway entirely with IPv6 addressing.
A. True: All IPv4 features are supported in IPv6'
B. True: Management can occur over IPv4 or IPv6 thus all gateways can have interfaces configured with valid IP addresses of either type'
C. False: There are many common IPv4 features that are not supported in IPv6'
D. False: Management only occurs over IPv4 thus all gateways are required to have interfaces configured with valid IPv4 addresses'
You enabled IPv6 in your environment and would like to erase all IPv6 connection tables. How can you do it?
A. fw tab t connections x
B. fw tab t connections6 x
C. clear connections table ipv6
D. fw6 tab t connections x
What is the length of an IPv6 address?
A. 128 Bytes
B. 54 bits
C. 128 bits
D. 6 Bytes
In a ClusterXL that uses IPV6 Address, how do you configure the sync interface?
A. You must configure synchronization interfaces with an IPv4 address only.
B. If an interface does not require IPv6, only the IPv4 definition address is necessary.
C. All interfaces configured with an IPv6 address must also have a corresponding IPv4 address.
D. You must configure synchronization interfaces with an IPv6 address only.
Which of these commands can be used to display the IPv6 routes?
A. show route
B. show ipv6 route
C. show routes all
D. show route ipv6
Which of these commands can be used to display the IPv6 status?
A. show ipv6-stat
B. show ipv6 all
C. show ipv6 status
D. show ipv6-status
Which of the following is true about Node / Host objects?
A. A Node / Host object can either have IPv4 or IPv6 IP address or have both.
B. A Node / Host object can either have IPv4 or IPv6 IP address but not have both. Separate objects need to be created for hosts that use dual stack.
C. A Node / Host object can only have IPv4 IP address. For IPv6, a Node / Host6 object must be used.
D. Node / Host object does not support IPv6, hence a Network object must be created for IPv6.
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only CheckPoint exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 156-115.77 exam preparations and CheckPoint certification application, do not hesitate to visit our Vcedump.com to find your solutions here.