Free RPFT Exam Dumps Preview

Prior to performing a multiple-breath U2 washout test, a pulmonary function technologist is unable to zero the H2 gas analyzer.

Which of the following may be responsible?

A patient is performing a flow-volume loop. A pulmonary function technologist observes equal decreases in expiratory and inspiratory flows resulting in plateaus. Patient effort is satisfactory, and he follows instructions well. The technologist should expect the patient to have a

At the end of a progressive exercise study of a healthy adult male, RER would be approximately what value?

Which of the following is the most reliable method to estimate the effectiveness of standard procedures to minimize the risk of cross-contamination during spirometry testing in a pulmonary function laboratory?

Which of the following may cause a reduction in end-tidal CO2?

Which of the following is a suitable policy for following Standard Precautions in a pulmonary function laboratory?

During calibration of a spirometer, injection of air with a 3-liter syringe results in the following:

Using another 3-liter syringe, air is again injected with the following results:

A pulmonary function technologist should conclude that the

The normal response to an increasing PaCO2 is

A 54-year-old male with a normal ECG at rest develops dyspnea during an exercise (stress) test, and the following ECG pattern is noted at 25 watts:

25 mm/sec A pulmonary function technologist should

The following Levy-Jennings charts of control values are obtained:

Which of the following is the correct sequence of actions for a pulmonary function technologist to take?

1. Replace the oxygen electrode.
2. Check the temperature of the measuring chamber.
3. Run protein remover through the blood gas analyzer.
4. Replace the CO2 electrode.

A 40-year-old woman with a recent onset of asthma is receiving education regarding her newly prescribed medications.

Which of the following will most likely cause her to experience hoarseness?

A biologic control subject has a FRCpleth of 4.0 ?.3 L at panting frequencies between 60 and 70/min.
During a QC run, the subject pants at 55/min and a FRCpleth of 3.90 L is recorded.

Which of the following is the most appropriate action to take?

A pulmonary function technologist is performing quality control on a nebulizer used in the 5-breath dosimeter bronchial challenge. The target output of the device is 0.09 mL, plus or minus 10%. After 10 actuations, the nebulizer output was 75 with a 2.0 mL initial saline dose in the nebulizer. The technologist should

A pulmonary function laboratory routinely tests five subjects as biologic controls. Acceptable instrument performance over time is indicated when measurements

To check the reliability of a pulse oximeter reading, a pulmonary function technologist should

The following data are obtained for a 60-year-old male undergoing an exercise (stress) test on an ergometer:

A pulmonary function technologist should

To facilitate measurement of arterial oxygen content during an exercise (stress) test, a pulmonary function technologist should recommend