Free NS0-521 Exam Dumps Preview

An administrator has a NetApp AFF cluster supporting an application with twelve LUNs allocated across four volumes. There is a requirement to configure a Snapshot copy of all LUNs simultaneously as a single unit.

Which NetApp ONTAP command should be used to configure this requirement?

A customer has a two-node NetApp ONTAP cluster that Is hosting FC LUNs for 64 SAN hosts. An administrator is tasked to add 40 more hosts to the environment.

What two actions would the administrator need to take to avoid potential performance problems with the environment? (Choose two.)

A storage engineer is required to provide NetApp site design documentation to show that the NetApp ONTAP SAN solution was delivered as intended.

Which NetApp tool can the storage engineer use to automate the creation of a difference report?

An administrator finishes an installation of a new NetApp ASA system at the customer site and creates a new LUN. The customer wants to restrict the access of the LUN to specific UFs.

Where would the administrator configure this?

An administrator is configuring ISCSI on an SVM and requires that all network traffic Is encrypted.

What must be done to satisfy this requirement?

What is the maximum size for a LUN in NetApp ONTAP 9.14.1 software?

A customer wants to Implement a NetApp AFF system at a small remote site that has two ESXi servers that require SAN storage from the NetApp ONTAP based storage system. The servers will be directly connected, because the customer does not want to deploy any switches.

Which protocol should the customer use?

An administrator installs a new NetApp ONTAP system in a customer's SAN environment. The customer wants to confirm that ALUA correctly changes the path states between Active/Optimized and Active/
Nonoptimized.

Which event causes ALUA to change the path states?

What connectivity Is required between NetApp ONTAP clusters in order to configure SnapMirror active sync across two data centers for FC?

A customer has a 10GB volume with an 8GB LUN that is using 7GB. The snapshot policy is hourly and retains 48 snapshots. After a ransomware attack that encrypts all files on the LUN, the customer notices that all snapshots are gone.

What could cause this behavior?