Free NS0-504 Exam Dumps Preview

What must you specify when you create a Vserver for block protocols?

What happens when a node loses SAN protocol quorum? (Choose two.)

What does Storage Failover allow?

Normally, before you split a SyncMirror volume, you ensure that both plexes are _______ and _______.

Which statement is true about converting an aggregate from 32-bit to 64-bit?

A company is planning to use physical Raw Device Mappings (RDMs) in their ESX environment.

Which LUN type should they use on the NetApp storage system if they want to prevent LUN I/O alignment issues?

Which command do you use on a Brocade switch to view all defined zone configuration information?

A NearStore license increases the amount of concurrent replication streams.

Which MetroCluster configuration procedure is recommended for re-establishing a mirrored volume that was in a level-0 resynchronization state when it failed?

Each storage system in a cluster must have network access to the __________.

Which two commands on the storage system allow you to gather detailed statistics about network interfaces, including basic information about network connections? (Choose two.)

Which three tasks should be completed as part of the site preparation for install? (Choose three.)

Using the following path: /users/sales/a1/smith, which are the two possible path types for 1? (Choose two.) Using the following path: /users/sales/a1/smith, which are the two possible path types for ?
1? (Choose two.)

Is NetApp storage Encryption supported in Data ONTAP 8.1.1 Cluster-Mode?

On ESX 4.0 for guest operating systems in a Microsoft cluster configuration, the Path Selection Plug-in (PSP) for a MSCS LUN should be set to:

Which two statements apply to the fs_size_fixed volume option? (Choose two.)

In a Fibre Channel configuration, the host's HBA is referred to as the ___________, and the storage system's HBA is referred to as the __________ .

A company has five Windows servers that are dual-attached, four Linux servers that are single attached, and ten dual-attached Solaris servers. The company wants a highly available architecture. A dual controller FAS3100 series with all onboard FC ports connected to the fabric is being proposed.

What is the total number of FC ports and what type of fabric should be deployed from the choices shown?

DRAG DROP

After upgrading to DOT 8.0 7-mode, you can convert existing 32-bit aggregates into 64-bit aggregates.

The VLDB is out-of-quorum on the node serving as the master of the VLDB ring.

Which four statements are true? (Choose four.)

You are having problems accessing three recently-created LUNs. Given the output below, the reason is because all of the LUNs are using the same LUN ID of 0.

lun show -m
LUN pathMapped to LUNID
---------------------------------------------------
/vol/vol1/lun0 solaris-igroup0 0
/vol/vol1/lun1 windows-igroup 0
/vol/vol1/qtree1/lun2 aix-igroup 0
/vol/vol1/qtree1/lun3 linux-igroup 0

To collect per client NFS statistics on a storage system, the option nfs.per_client_stats.enable must be set on.

Which four statements are true about a node's vol0 volume? (Choose four.)

What should you do to verify FC connectivity between the host and the FC switch?

Which four steps must an administrator take before establishing a CIFS share? (Choose four.)

Which two are Data ONTAP commands for creating LUNs on a storage system? (Choose two.)

What is the maximum number of nodes in a cluster that the Cisco Nexus 5010 supports?

Operations Manager can monitor and manage only NetApp storage hosts that have the NetApp Host Agent installed.

Which two Volume SnapMirror (VSM) relationship are supported? (Choose two)

The snapvault snap sched -x command is used to ____________.

To remove a cluster setup, you must perform these steps:

1. Type cf disable.
2. Unlicense cluster.
3. Remove partner entries for network interfaces from the /etc/rc file.
4. Halt and make sure the partner-sysid is blank.
5. Power down and remove the cluster interconnect card.
6. Perform steps 1-5 above on the partner node.

Which is a supported management switch?

When does Fractional Reservation reserve space from the volume?

Which command do you use on a Cisco switch to view the currently active zoneset?

With Data ONTAP 8.1, which statement is true about deduplication and volume sizes?

Click the Exhibit button.

Based on the diagram shown, what is the appropriate FC switch topology?

For which two purposes would the use of VLAN's be beneficial to a NetApp storage solution? (Choose two.)

You want to create an automated test environment that performs a single file SnapRestore time you run the procedure, however, SnapRestore prompts you to confirm your decision to revert the file.

How can you automate this step?

When creating a LUN, you use the LUN's OS type to specify which two? (Choose two)

The two copies SyncMirror volume are called ____________, which are physical copies of the same file system and consist of one or more RAID groups.

Which mechanism allows you to make LUNs available to some initiators and unavailable to others?

Which three /etc/snapmirror.conf entries will support synchronous or semi-synchronous SnapMirror?

Which two modes support using SnapMirror over multiple paths?

For controller-specific information on hardware deployment details such as rack power and cable management, where can you find information?

Protection Manager is an optional component of the Operations Manager that can be licensed and accessed from the NetApp Management Console (NMC).

A company has a Fibre Channel environment and wants to connect a new host in a remote data center using 50/125um OM2 multi-mode fiber cable and needs to support 2 Gb speeds.

What is the maximum distance of the cable run supported in this situation?

Zoning by World Wide Port Name (WWPN) is deployed and a host HBA is replaced.

Which zone change needs to be made?

Which type of zoning does NetApp recommend?

To configure a storage system as a member of a Windows active directory domain, the time on the storage system must be set to be within plus or minus five minutes of the time on the domain controller.

Which is NOT a reason to zone your fabric?

Which two SMB versions does Data ONTAP Cluster-Mode support? (Choose two.)

What is the storage system command line interface command fcp adapter show used to determine?

Which three does NetApp support for iSCSI with Microsoft Windows solutions? (Choose three.)

NetApp storage systems require which information to configure the storage system for management tools? (Choose two.)

Which task is part of the site preparation for installation?

Which are three valid data protection solutions? (Choose three.)

When using MetroCluster in a forced takeover mode, identify two methods for restricting access to the
disaster site node. (Choose two.)

To ensure path redundancy and load balancing you must configure each host for________.

Which of these attributes can affect LUN I/) alignment?

Which two operations can be performed with the SnapDrive for windows graphical user interface?

Which command displays the disk ownership for both CPU modules in a FAS2020 system?

Which set of commands should be used for troubleshooting Ethernet connectivity problems from the storage system console?

Click the Exhibit button.

Include self assessment and reporting features

In the diagram shown, a portset is created on controller 1 with the command: controller1>portset create -f
ntapportset 0b. This portset is bound to the igroup with all the initiators in it.

How many paths can host 1 see to a LUN on controller 1?