Free NS0-163 Exam Dumps Preview

Which one of the following is not a pre-requisite for using SnapRestore?

A NearStore system or storage appliance can operate as a secondary and primary system at the same time.

To remove a cluster setup, you must perform the following steps.

1. Type cf disable.
2. Unlicense cluster.
3. Remove partner entries for network interfaces from the /etc/rc file.
4. Halt and make sine the partner-sysid is blank.
5. Power down and remove the cluster interconnect card.
6. Perform steps 1-5 above on the partner node.

A volume is SnapMirrored hourly. You revert the volume using a snapshot that was created two days ago.

Which command continues the relationship?

Which native ONTAP feature allows an administrator to block a Windows user from writing files with the .
crypto extension?

Open System SnapVault agents can be installed on all non-Network Appliance platforms.

Which three are required licenses for Fabric Attached MetroCluster? (Choose 3)

In a synchronous SnapMirror configuration, the soui'ce storage appliance exhibits high latency due to user traffic and rapid data change from SnapMirror transactions.Which one of the following tuning methods best resolves this performance behavior? Edit the /etc/snapmirror.conf file on the destination storage appliance and set:

XML-files in /etc/stats/preset are used together with the sysstat command to customize the output.

Which objects can be restored by a single SnapRestore command? (Choose three)

Which two SVM types can host intercluster LIFs? (Choose two.)

The snapvault snap sched-x command can be used to:

You have connected all cables and disk shelves in a Fabric Attached MetroCluster.

Which one of the following commands would you use to verify that disks are connected and have dual paths?

An administrator has an ESXi cluster with VMware VMFS LUNs on an AFF system. After troubleshooting performance issues, the administrator determines that timeout best practices are not set on the hosts.

Which NetApp tool would apply the best practice settings?

Which two supported methods would you use to restore data from a SnapVault for Net Backup Volume?

Which tool is available on a non-NetApp primary system to assist in starting or stopping Snap Vault, modifying NDMP settings, enabling debugging, and capturing trace files?

You have quiesced a volume to stabilize the contents of a destination just prior to a snapshot.

What is the next logical command that you would issue after the snapshot is complete?

The snapvault restore command is ran on the:

SnapVaulr snapshots for SnapLock volumes are deleted automatically according to the retention count set in the SnapVault schedule?

In a fabric-attached MetroCluster, hardware disk ownership by a node is determined by which two factors (Choose two.)

NetApp X1024 Fibre Channel HBA is required on the storage systems for IP over Fibre Channel functionality.

What NetApp tool collects data from ONTAP AutoSupport to report health, performance, capacity and efficiency?

When you create a restricted volume to be used as the destination for SnapMirror data replication, which command allows you to check the size of the source and destination volumes?

The snapvault snap create volume snapname command can be executed on the__________.

Which one of the following actions will cause a currently in sync snapmirror relationship to fall out of sync?

Which one of the following is a recommended secondary system for SnapVault?

You cannot disable the SyncMirror license if one or more mirrored volumes exist.

Which option of the snap restore command allows you to specify a different directory, as long as the directory already exists?

In a Fabric Attached MetroCluster, a "disaster" is described as a:

An administrator is troubleshooting connection problems with ONTAP System Manager. The cluster management LIF is port a0a-33. Web clients on VLAN 33 are able to access System Manager. Web clients on other subnets are unable to reach System Manager.

Which network component should the administrator modify?

An administrator has an existing FlexVol accessed by Linux hosts over NFSv3. A CIFS share to the same FlexVol was created for SMB access. Windows users are unable to view the share. CIFS share

permissions allow for read and write access for the Windows users.

What does the administrator need to modify to allow SMB access?

Which one of the following /etc/snapmirror.conf entries will not support synchronous SnapMirror?

You want to create an automated test environment that performs a single file SnapRestore. Every time you run the procedure, however, SnapRestore prompts you to confirm your decision to revert the file.

How can you automate this step?

Fill in the blank for the following statement: To manage a SnapVault backup through a commercial NDMP application, you must specify a_____authorized through that application.

Which two interfaces can an administrator use to disable unused Ethernet ports on an ONTAP cluster? (Choose two.)

What console message is a good indication that the storage appliance is ready to reinstate the cluster from a previous takeover?

The two copies of a SyncMirror volume are called_______. Each______is a physical copy of the same file system and consists of one or more RAID groups.

You can unlicense the cluster feature only in mode with cluster: