Free LSSYB Exam Dumps Preview

Systems and structures are the basis for allowing people to change their behaviors permanently and are accomplished through which of the following?

In the expression Y = f(Xn) Y, the output, is the ___________ variable and Xn, the inputs, are the
__________ variables.

A 5

Why Analysis is used to help identify possible defect causes when which one of the below listed tools is created?

The measure which helps to understand the spread of variation is called as _____.

Six sigma project methodology normally begins with what initial step?

Which of these elements are not included in Implementation plans?

Due to excessive pollution, GREEN Solutions Inc. is considering subsidizing public transportation to work for its employees. According to the manager it takes an average weekday commute of 39 minutes with a Standard Deviation of 7 minutes for the employees to get to work while they use their personal vehicles for their office commute while the management set a policy of not more than 40 minutes for their daily one-way commute. A survey conducted one day on 70 employees showed an average of 34 minutes commuting time using the metro public transportation system with a Standard Deviation of 21 minutes.
Assuming a Normal Distribution for the commute times by either personal or public transportation, which of these is true?

Ratio and Interval Scale of measurements are based on _____ type of data:

Questions that can be best answered by a Visual Factory include all of these except _____.

Contingency Tables are used to test for association, or dependency, between two or more classifications.

An organization should apply Six Sigma techniques and tools according to its:

An important factor in a viable _________ is to determine who, when and to what level various personnel must be trained to maintain the improvements made to a process.

A Factorial Experiment based on a Level 2 Design with 6 factors would require 16 runs to fully assess the interactions.

Contingency Tables are used to perform which of these functions?

If a set of data is generally centered relative to the targeted value but is rather widely disbursed it would be said to be _____________.

Hypothesis Tests determine the probabilities of differences between observed data and the hypothesis being solely due to _____ based on the result of the Pvalues.

The Pareto Graph is used to represent _____ scale of measurement.

The traditional methods of obtaining customer information could also include:

Sally and Sara sell flower pots at their garage sale. Martha motivates Rose mentioning that they will sell a minimum of 16 pots per day if the outside temperature exceeds 60?F. From a sample, whose population is assumed to follow a Normal Distribution, taken for 30 days at 60 degrees or more an average of 15.2 pots per day were sold with a Standard Deviation of 0.6 pots.

What is the Z value for this sales process?

How many experimental runs exist in a Full Factorial and fully randomized design for 4 factors with 2 replicates for the Corner Points and no Center Points? The factors in the experiment are only at 2- levels.

If the production is for higher volume and monitoring and the Mean and variability is to be monitored for four machines producing product and the characteristic to be monitored is Variable Data, which SPC Chart is best to be selected?

Relative to a Design of Experiments the term _____ refers to variables being a linear combination of each other.

If a set of data is very similar in value yet far off the mark relative to the targeted value this data could be said to be:

Which best describes the purpose of Six Sigma?

With Measurement System Analysis we are concerned with Precision and _________________ of the data to be collected.

The actual experimental response data varied somewhat from what a Belt had predicted them to be.
This is the result of which of these?

Al bought a handheld GPS from his local electronics store. When he entered an address it would not function.
For the manufacturer of the GPS this would be categorized as what type of cost?

If a Six Sigma project was to reduce repair station inventory and the team found the inventory was creeping up over time which Lean tools should be considered in the Control Phase to reestablish and sustain the project success?

One of the primary deliverables from performing a SIPOC is to begin to understand which inputs have the greatest affect on the ____________ most valued outputs.

Which is NOT a benefit of a Resource Plan?

When a Belt implements an improvement that is automated thus requiring no particular understanding for use he has applied which Lean tool?

It is recommended that when beginning a 5S program the entire plant gets involved rather than starting it in a pilot work area and then spreading it to other areas.

80% of effects come from 20% of the possible causes. These 20% are called the:

Who is responsible for adherence to the Monitoring Plan?

An observation above upper Control limit is concluded as?

When a Belt decides to use written procedures and visual controls to improve the consistency of the tasks that must occur in the process he is improving he has utilized the _____ activity of 5S.

Which of the following is a method of expressing the concept that the outputs of a process are a function of all the inputs to the process?

It is also important to look at the market for the next two to five years and estimate how it will change and grow & this requires:

Three Standard Deviations on left and right side of the mean would include what % of the total data points in Normal Distribution?

What is not a part of Cause and effect diagram?

Hypothesis Testing can save time and help avoid high costs of experimental efforts by using existing data.

Which of the following is not a Measure of Central Tendency?

Lean focuses on analytical and statistical analysis to reduce variation in a process output.

As we conceive and define a LSS project one of the overriding things we hope to accomplish is to reduce the _____________________.

Project Charter is a document that provides:

When we create a Process Map and want to depict an action step in the process we would use the
____________ symbol.

Sally and Sara sell flower pots at their garage sale. Sally motivates Sara mentioning that they will sell a minimum of 15 pots per day if the outside temperature exceeds 60?F. From a sample, whose population is assumed to follow a Normal Distribution, taken for 30 days at 60 degrees or more an average of 13.6 pots per day were sold with a Standard Deviation of 0.7 pots.
For the sales accomplished above, what test would validate if they met their requirements?

Common and _____ Cause Variation are the focus of Statistical Process Control.

In an FMEA what is the RPN if S=9, O=5, D=4:

For the data shown here which statement is true?

The method of Steepest Ascent guides you toward a target inside the original inference space.