Free JN0-647 Exam Dumps Preview

A customer needs to pass Layer 2 protocols between sites.

Which protocol or standard would be required to implement connectivity on EX4300, EX3400, and EX2300 devices?

Which two statements about VSTP on EX series switches are connect? (Choose two.)

Click the Exhibit button.

Referring to the exhibit which two statements are true? (Choose two.)

A new PoE+VoIP handset was added to an EX Series device. The handset is experiencing connectivity issues. The EX Series device's committed configuration includes the set PoE interface all telemetry command. You look at the telemetry log in the device to review power consumption and you notice entries have not been occurring for days.

What would cause telemetry logging to stop?

Which protocol is a multicast routing protocol?

Click the Exhibit.

You are adding a Junos Fusion satellite device but one cascade port is not coming on line.

Referring to the exhibit, what would cause this problem?

Click the Exhibit button.

You have three switches, each with a trunk connection allowing all VLANs to the switches. CIST will converge, however MSTP will not.

Referring to the exhibit, which statement is correct?

You have certainly implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communicate with the appropriate community devices connected to AS-2.

What must be done to allow these community devices to communicate?

Click the Exhibit.

A customer requires that the switch responds to an ARP request only if the source and target IP address are on different subnets.

Referring to the Exhibit, how would you accomplish this task?

Click the Exhibit button.

Referring to the exhibit, Area 1 is a stub area.

Which two statements are correct in this scenario? (Choose two.)

Click the Exhibit button.

You are troubleshooting an OSPF adjacency issue between R1 and R2.

What is the reason for the ExStart state shown in the exhibit?

Your network supports multicast traffic but your provider network does not. You want to allow multicast hosts outside of your network to receive multicast traffic sourced within your network.

How would you satisfy this requirement?