Free HPE6-A41 Exam Dumps Preview

A network administrator prepares an ArubaOS switch to be monitored and managed by AirWave.

Which credentials are required for AirWave to change configuration settings on the switch?

Refer to the exhibit.

The student A client needs to connect to FTP Server B. Student A sends the necessary ARP request and receives a reply.

Which destination MAC address does the Student A client use in the FTP packet to FTP Server B?

How does a wireless network differ from a wired network?

How can a network administrator configure an ArubaOS switch to automatically assign the correct tagged VLANs to a port when an Aruba AP connects to that port?

Which type of 802.11 wireless network can be hosted by an endpoint device such as a laptop?

Refer to the exhibit.

A network administrator views the configuration files on an ArubaOS switch and sees the output in the exhibit. The administrator enters this command: Switch# boot system flash primary config config2

After the switch boots, the administrator makes some configuration changes and saves the configuration with the write memory command. The administrator then enters this command: Switch# boot

After the switch boots, the configuration changes just made are not present.

How can the administrator restore the configuration with the changes?

An interface on an ArubaOS switch did not receive any BDPUs and has the spanning tree auto-edge setting.

What describes the effect of this setting?

Member1 is the commander of a Virtual Switching Framework (VSF) fabric. A power distribution causes member 1 to go down. Now the network administrator wants to rejoin member1 to the VSF fabric and make member1 the commander again.

What should the administrator do?

A network administrator plans to set up a WLAN on an Aruba Instant cluster. The WLAN uses WPA/WPA2
Enterprise security. The administrator wants no authenticate users locally on the cluster.

How should the administrator configure me credentials?

Refer to the exhibit.

Exhibit 1.

Exhibit 2.

Which devices can communicate with each other at Layer 2?

How many operating system image files can a network administrator load on an ArubaOS switch?

Which configuration settings for an ArubaOS switch must be deleted from a physical interface before it can be associated with a Virtual Switching Framework (VSF) link?

Refer to the exhibit.

The switches in the exhibit are all ArubaOS switches that run MSTP. The network administrator wants all of the switch-to-switch links shown in the exhibit to be available for forwarding routed traffic.

What should the administrator do to accomplish this?

A network administrator needs to configure a link aggregation on an ArubaOS switch.

For which type of link aggregation is the administrator required to enter the lacp command in the interface context?

Refer to the exhibit.

A company has an existing Aruba Instant cluster with several Instant APs (IAPs), as shown in the exhibit.
The network administrator orders a new IAP and boots it for the first time by connecting it to the PoE switch port shown in the exhibit.

What happens after the IAP boots?

Refer to the exhibit.

Exhibit 1.

Exhibit 2.

Which devices can communicate with each other at Layer 2?

Refer to the exhibit.

The network administrator enters this command: Switch(config)# ip route 172.16.2.0/30 192.168.1.100 metric 1 distance 1

Why does this route fail to appear in the IP routing table?

A network administrator connects an Aruba Instant AP (IAP) to an ArubaOS switch but cannot connect the AP to the Instant cluster that exists. The administrator wants to check the IAP management IP address and software version from the ArubaOS switch CLI.
To obtain this information, what should the administrator ensure is enabled on the switch and switch interfaces?

For which task does a network administrator need to access the enable context on an ArubaOS switch?