Free HPE0-S58 Exam Dumps Preview

A customer needs to aggregate uplink ports from two Virtual Connect interconnects to increase bandwidth and availability of the networks configured for HPE Synergy platform.

Which steps must the integrator perform in the configuration to meet the customer's needs?

An integrator is performing initial configuration of three-frame Synergy solution with HPE Image Streamer.

Which networks must be created for this configuration? (Choose two.)

Which HPE Synergy D3940 storage module configuration is valid?

A customer is considering implementing a DRS cluster, but they would like to know how DRS can help to achieve performance goals.

How should an integrator respond?

An integrator has planned a highly available Synergy Composable Fabric with 20Gb Interconnect Link Modules.

What is the maximum number of SY 480 Gen10 compute modules the integrator can install into this configuration?

Which management tool required by HPE Infosight must be deployed at the customer site?

A customer is using HPE Synergy Composer to manage the compute module and 3PAR volume attachments. The datastore attached to the VMware servers has run out of space.

What is the most efficient procedure the integrator should follow to extend the volume with minimum effect on the compute modules?

Which component must be deployed at the customer site and is essential for HPE InfoSight for Servers?

A customer is planning an HPE Synergy solution with 20 frames and needs to minimize the number of management ports that are required to connect the frames into the existing management network.

Which procedure should the integrator use to address the customer's concern?

Refer to the exhibit.

A customer with the design shown needs to perform an in-place upgrade to its environment to scale the two-frame single homed Multimodule Link Aggregation Group (MLAG) configuration to a three-frame configuration. The new frame needs to provide a redundant 20Gb connection for the compute module ports in Fabric 3.

Which interconnect modules should the integrator use in Frame 3?

A customer wants to add nodes to the existing ESXi cluster using the HPE OneView for vCenter Server.

What must be done before this functionality can be used?

A customer needs to significantly improve I/O performance to a database server.

Which product should an integrator implement as part of a Synergy composable solution?

HOTSPOT

An integrator needs to re-deploy a specific firmware component to one of the Synergy compute nodes.

Click on the option that will allow an integrator to rewrite existing firmware components with the same

option.

A customer has the following configuration:

Frame 1
Bay 1 - HPE Synergy 12Gb SAS Connection Module
Bay 2
Bay 3 - HPE Virtual Connect SE 40 GB F8 Module
Bay 4 - HPE Synergy 12GB SAS Connection Module
Bay 5
Bay 6 - HPE Synergy 10 Gb Interconnect Link Module

Frame 2
Bay 1 - HPE Synergy 12Gb SAS Connection Module
Bay 2
Bay 3 - HPE Synergy 10Gb Interconnect Link Module
Bay 4 - HPE Synergy 12Gb SAS Connection Module
Bay 5
Bay 6 - HPE Virtual Connect SE 40Gb F8 Module
How many more frames can the customer add to their Synergy composable fabric?
(Note: Enter your answer in the answer field below.)

A customer needs to deploy HPE Global Dashboard appliance, but experienced vCenter Server failure and
cannot access ESXi servers.

How can the customer connect to the specific ESXi server to power on important virtual machines?