Free HP2-Z37 Exam Dumps Preview

Refer to the exhibit.

Examine the partial HP switch output shown in the exhibit.
Based on this output, if the switch receives a packet with a destination IP address of 10.2.90.87, which entry in the routing table would the switch use to forward the packet?

Refer to the exhibit.

This switch currently assigns all VLANs to Multiple Spanning Tree Protocol (MSTP) instance 0 or the Internal Spanning Tree (IST).

Which statement correctly describes interface 21?

Refer to the Exhibit.

A network administrator has configured an HP Comware switch to act as the DHCP server for VLAN 12, but the switch is not responding to clients' DHCPDISCOVER messages.
Based on the exhibit, what is the problem with the DHCP configuration?

Refer to the exhibit.

A network administrator sets up OSPF in part of the network topology shown in the exhibit. The Comware- 1 switch is already configured. The administrator needs to configure ProVision-1 so that:

- OSPF includes VLANs 10 and 20 in the routing process.

- The router ID of 1.1.1.1 is assigned to the switch.
- The ProVision-1 switch can successfully build a neighbor adjacency with the Comware-1 switch.

Which configuration should the administrator apply to the ProVision-1 switch to meet these requirements?

On an HP Comware switch, which view must an administrator access in order to execute the debug command?

A network administrator enters this command on an HP Comware switch:

<Comware> save

In interactive mode, the administrator is prompted to save to a file named config.cfg and confirms the save.

What is the effect of these actions?

A network administrator configures this command on an HP ProVision switch:

vlan 30 ip helper-address 10.0.3.253

The switch is able to ping 10.0.3.253. After the administrator configures the command, users in VLAN 30 report that their PCs fall to acquire addresses using DHCP.

What should the administrator ensure?

Which HP device or port type can modify, read, and respond with frames that include 802.1Q VLAN tags?

Which ProVision configuration includes 10.0.3.0/24, which represents VLAN 30 in OSPF area 0?

A tagged frame arrives on a switch port that is not a tagged member of the VLAN indicated by the frame ID.

What do fundamental VLAN operating rules require the switch to do with that frame?

When adding a new member to an existing IRF domain, which of the following must you perform first?

A network administrator is managing an HP Comware switch from the CLI.

Which action can the administrator only perform in User view?

How does a switch treat a link aggregation?

Which HP Comware term defines the untagged VLAN on a trunk port that is commonly used for network management traffic?

A network administrator needs to restrict access to the console port of an HPE Comware switch. When a user connects to the console port and opens a terminal session, the switch should prompt the user for a password.

How should the administrator configure user interfaces on the Comware switch?

A customer is implementing a network using HP ProVision switches.

Which default setting applies to the ProVision switches?

A network administrator is configuring a static route.

What should the administrator use as the next hop address?

An HP Provision switch has port A1 connected to port g1/0/1 of an HP Comware switch.

The ProVision port has the following configuration: vlan 1 untag A1 vlan 10 tag A1 vlan 20 tag A1 Which Comware configuration will allow the three VLANs to successfully pass traffic between the two switches?