Free HP2-Z33 Exam Dumps Preview

A corporate user accesses a corporate network on SSID CORPORATE. The user endpoint is set up for
802.1X in PEAP-MSCHAPV2:

HP BYOD is implemented.
Wireless is set up on an HP Unified Wired-Wireless Controller Accounts have been synchronized with an Active Directory Domain controller.

Which configuration is validated by successfully accessing SSID CORPORATE?

Refer to the exhibit.

A client can roam successfully between AP1 and AP2. However, the client is unable to roam between AP2 and AP3.

What could be the problem?

A customer has an HP BYOD solution based on an HP 830 Unified Wired-Wireless Controller and HP 425
Access Points (APs). To ease the controller adoption of the APs, a VLAN is set up on the corporate LAN.

How should this VLAN be configured?

Which command allows an administrator to access the HP 830 switch CLI from the controller?

When accessing the wireless network in 802.1X with EAP-TLS, what do the user endpoints require?

Refer to the exhibit.

Based on the access controller configuration shown in the exhibit, when can newly discovered access points (AP) join this AC?

A network administrator sets up the DHCP relay on an HP Comware Layer 3 device that forwards IP traffic between the VLANs associated with the wireless SSID with these commands.

What must the administrator configure prior to enabling the DHCP relay to the DHCP server on 10.0.0.200 in the interface vlan-interface 100?

Which action does the Wireless Intrusion Prevention System (WlPS) take when it detects that a device is sending frames with a fixed initialization vector?

What is an attribute of an autonomous AP?

To allow user access for corporate employees, a network administrator sets an SSID named CORPORATE using an HP Unified Wireless solution. The administrator wants these security enhancements:

Enable 802.1x authentication in PEAP MS-CHAP V2 mode on this SSID along with AES and WPA2.
Set the User Access Manager server at 10.0.1.100 to authenticate 802.1x supplicants.
The network administrator enters these commands:

What is another set of commands that must be entered onto the Unified Wireless Controller in system-view mode to define the SSID CORPORATE with 802.1X Authentication in PEAP MSCHAPV2, using the defined RADIUS server?