You have just manually failed over Redundancy Group 0 on Node 0 to Node 1. You notice Node 0 is now in a secondary-hold state.
Which statement is correct?
A. The previous primary node moves to the secondary-hold state because an issue occurred during failover. It stays in that state until the issue is resolved.
B. The previous primary node moves to the secondary-hold state and stays there until manually reset, after which it moves to the secondary state.
C. The previous primary node moves to the secondary-hold state and stays there until the hold- down interval expires, after which it moves to the secondary state.
D. The previous primary node moves to the secondary-hold state and stays there until manually failed back to the primary node.
When using chassis clustering, which action is taken by the Junos OS if the control link or the fabric link suffers a loss of keepalives or heartbeat messages?
A. Both nodes become primary.
B. Both nodes are placed in a disabled state.
C. The secondary node is placed in a disabled state.
D. The primary node fails over and is placed in a disabled state.
Which statement is true about real-time objects in an SRX chassis cluster?
A. Real-time objects are exchanged over the fxp1 link to provide highly accurate time synchronization.
B. Real-time objects are exchanged over the fxp1 link to synchronize IPsec security associations.
C. Real-time objects are exchanged over the fab links to provide configuration file synchronization.
D. Real-time objects are exchanged over the fab links to synchronize session table entries.
Which two statements are correct regarding the cluster ID? (Choose two.)
A. You can have up to 15 unique cluster IDs on a single chassis cluster device.
B. The cluster ID value of 0 indicates that this is the primary chassis cluster on this device.
C. The cluster ID is used to calculate the reth interface's virtual MAC addresses.
D. You must reboot both nodes if you change the cluster ID value.
You are asked to establish a chassis cluster between two branch SRX Series devices. You must ensure that no single point of failure exists.
What would prevent a single point of failure?
A. dual data plane links
B. redundant routing tables
C. redundant cluster IDs
D. dual control plane links
When using chassis clustering, which link is responsible for configuration synchronization?
A. fxp0
B. fxp1
C. fab0
D. fab1
Redundant Ethernet interfaces (reths) have a virtual MAC address based on which two attributes? (Choose two.)
A. interface ID of the reth
B. MAC of member interfaces
C. redundancy group ID
D. cluster ID
What is supported on the fabric link?
A. jumbo frames
B. filters
C. fragmentation
D. policies
You are asked to establish a chassis cluster between two SRX Series devices. You must ensure that endto-end connectivity is monitored and that the redundancy group will fail over to the other node if the remote device becomes unreachable.
What would ensure this behavior?
A. Bidirectional Forwarding Detection
B. real-time performance monitoring
C. remote interface monitoring
D. remote IP address monitoring
You are asked to set up a chassis cluster between your SRX Series devices. You must ensure that the solution provides both dual redundant links per node and node redundancy.
Which setting should you use?
A. aggregated Ethernet
B. redundant Ethernet
C. aggregated Ethernet LAG
D. redundant Ethernet LAG
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Juniper exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your JN0-332 exam preparations and Juniper certification application, do not hesitate to visit our Vcedump.com to find your solutions here.