Huawei Huawei Certification H12-211 Questions & Answers

• Question 701:

  Following a failure of services in the network, an administrator discovered that the configuration in one of the enterprise routers had been changed. What actions can be taken by the administrator to prevent further changes? (Choose three)

  A. The administrator should limit access by setting the login privilege of users to 0.

  B. The administrator should configure AAA to manage user authorization on the router.

  C. The administrator should configure an ACL to allow only the administrator to manage the router.

  D. The administrator should configure port-security on the router

  Correct Answer: ABC

• Question 702:

  [RTA]acl 2001 [RTA-acl-basic-2001]rule 20 permit source 20.1.1.0 0.0.0.255 [RTA-acl-basic-2001]rule 10 deny source 20.1.1.0 0.0.0.255

  Refer to the configuration output. Which of the following statements is correct regarding the configuration of the ACL on RTA?

  A. Packets from network 20.1.1.0/24 network will be denied.

  B. Packets from network 20.1.1.0/24 network will be permitted.

  C. Packets destined for network 20.1.1.0/24 will be denied.

  D. Packets destined for network 20.1.1.0/24 will be permitted.

  Correct Answer: A

• Question 703:

  [RTA]acl 2001 [RTA-acl-basic-2001]rule deny source 172.16.1.1 0.0.0.0 [RTA-acl-basic-2001]rule deny source 172.16.0.0 0.255.0.0

  Refer to the configuration output. Which of the following statements are correct regarding the configuration of the ACL on RTA? (Choose two).

  A. Packets from network 172.16.1.1/32 will be denied.

  B. Packets from network 172.16.1.0/24 will be denied

  C. Packets from network 172.17.1.0/24 will be denied

  D. Packets from network 172.18.0.0/16 will be denied.

  Correct Answer: AD

• Question 704:

  The network administrator wants to improve the performance of network transmission, what steps can the administrator take? (Choose two)

  

  A. Change the work mode to full duplex of each end station.

  B. Link the end stations together using a switch.

  C. Change the work mode to half duplex of each end station.

  D. Link the end stations together using a hub.

  Correct Answer: AB

• Question 705:

  On Huawei switch, which of the following commands can be used to set port duplex mode as "auto negotiation"? (Choose two)

  A. duplex negotiation auto

  B. duplex auto-negotiation

  C. duplex auto

  D. undo duplex

  Correct Answer: CD

• Question 706:

  The network administrator wishes to transmit data between two end stations. The network interface cards of both devices operates at 100Mbps however one supports half duplex while the other uses full duplex

  mode.

  What will occur as a result?

  A. The end stations cannot communicate.

  B. The end stations can communicate, but data may be lost during transmission of large amounts of traffic.

  C. The end stations will operate normally

  D. The end stations can communicate, but speed is different during transmission of large amounts of traffic.

  Correct Answer: B

• Question 707:

  An Ethernet port can work one of three duplex modes, whereas an Optical Ethernet port only supports one single mode. Which of the following represents this mode?

  A. Full-duplex

  B. Half-duplex

  C. Auto-negotiation

  D. Simplex

  Correct Answer: A

• Question 708:

  While inspecting packets in the network, a network administrator discovers a frame with the destination MAC address of 01-00-5E-A0-B1-C3. What can the administrator determine from this?

  A. The MAC address is a unicast address.

  B. The MAC address is a broadcast address

  C. The MAC address is a multicast address.

  D. The MAC address is incorrect

  Correct Answer: C

• Question 709:

  According to OSI reference model, which layer is responsible for end to end error checking and flow control?

  A. Physical layer

  B. Data link layer

  C. Network layer

  D. Transport layer

  Correct Answer: D

• Question 710:

  Which of the following mechanisms are used for flow control? (Choose three)

  A. Acknowledgement

  B. Buffering

  C. Source quench messages

  D. Windowing

  Correct Answer: BCD