Dell Dell Certification DC0-200 Questions & Answers

• Question 21:

  When you create a logical drive using the Create Volume Wizard, the logical drive size is prefilled on the Select Partition Type screen. What does this logical drive size indicate?

  A. the minimum logical drive size that can be created on that drive

  B. the suggested logical drive size that should be created on that drive

  C. the maximum logical drive size that can be created on that drive

  D. the logical drive size from the previously created logical drive

  Correct Answer: C

• Question 22:

  Which action would you take to convert a 1x6 backplane to a 2x3?

  A. add a second SCSI controller card

  B. install a power distribution board

  C. install an interposer board

  D. attach a daughter card

  Correct Answer: D

• Question 23:

  You only configure a PowerEdge Server running Dell OpenManage Server Administrator with community names for read access. You then configure OpenManage IT Assistant to use the same community names for both read and write when configuring the subnet in ITA to discover that system. Which two management functions are you able to perform on that system from ITA? (Choose two.)

  A. shut down the system remotely from ITA

  B. discover and monitor the health of that system from ITA

  C. see an inventory report of the system in ITA

  D. log in to the system from ITA and change its temperature thresholds

  Correct Answer: BC

• Question 24:

  Which OpenManage component is installed on the management station to receive SNMP alerts from managed systems?

  A. IT Assistant

  B. Remote Access Controller

  C. Server Assistant

  D. Server Administrator

  Correct Answer: A

• Question 25:

  You are attempting to install OMSA on a system. The only option offered by the installation GUI is Management Station. What are the two most likely causes for this? (Choose two.)

  A. You are attempting to install OMSA from the management station CD-ROM.

  B. You are attempting to install OMSA on a non-supported Dell PowerEdge server.

  C. You are attempting to install OMSA on a non-PowerEdge Dell system.

  D. You are attempting to install OMSA from a network-shared CD-ROM drive.

  Correct Answer: BC

• Question 26:

  What does virtual disk refer to, as used in Dell Array Manager?

  A. contains the physical view of storage entities such as controllers, channels, and array disks

  B. array disks or array disk segments presented to the OS as a single continuous block of storage space

  C. a block of storage accessed by a drive letter

  D. a single array disk in an array of disks

  Correct Answer: B

• Question 27:

  Which four steps are necessary for creating a team in Windows 2000 using BASP? (Choose four.)

  A. create a team and assign it a name

  B. configure the IP address and subnet mask for the team

  C. select the adapters from the list to add to the team

  D. set the media type for the adapters

  E. select the Broadcom Advanced Server Program Driver

  F. enter the path and filename of the configuration to be saved

  Correct Answer: ABCE

• Question 28:

  Which two operations can be performed with the DSA CD? (Choose two.)

  A. run system diagnostics on your server

  B. create NetWare 5.1/6.0 driver/utilities diskette(s)

  C. change the Dell Service Tag via the Service Tag Utility

  D. create Windows 2000 driver/utilities diskette(s)

  Correct Answer: BD

• Question 29:

  Which two must be included in the setup of SNMP to properly configure it? (Choose two.)

  A. NetBEUI

  B. Get All operations

  C. trap destination

  D. community name

  Correct Answer: CD

• Question 30:

  What is the intended mounting location for a 0U rack mount device in a Dell rack?

  A. in the mounting holes in the side walls of the rack

  B. in any of the 42U spaces available

  C. on the back doors of the rack

  D. at the top of the rack

  Correct Answer: A