Free DES-5121 Exam Dumps Preview

What are key features of the Dell EMC N4064 or N4064F switches?

An administrator just finished configuring a Dell EMC N-Series switch. After rebooting the switch, the administrator notices that all the configuration settings just entered are gone.

Which command did the administrator fail to enter?

In order to alter a packet's routing direction, which packet layers can policy-based routing use?

You need to configure OSPF on a DNOS 6 switch and have entered the following:

Switch-1(config)# ip routing
Switch-1(config)# interface vlan 20
Switch-1(config-if-vlan20)# ip address 10.1.20.1 255.255.255.0

Switch-1(config)# router ospf
Switch-1(config-router)# router-id 10.1.1.1 Based on the information referenced above, what is missing from the configuration?

A network administrator wants to configure an ACL to deny traffic for a specific source IP and source UDP port.

Which type of ACL should be used?

What is the maximum number of dynamic MAC addresses that can be learned on a Dell EMC N-Series switchport that is configured for dynamic locking?

Which Layer 3 protocol does MLAG support?

Which packet characteristics can policy-based routing be configured to match against?

Which switchport mode is recommended for ports on a Dell EMC N-Series switch with IP phones using voice VLAN?

When configuring a Dell EMC N-Series switch for voice traffic, which settings are needed?