Free DES-1721 Exam Dumps Preview

Why should Legacy Port Mode be selected rather than Virtual Port Mode on an SC Series storage array?

Where are Dell Storage Manager (DSM) automated reports stored for later access?

How much memory is required if a customer plans to use the Dell Storage Replication Adapter for VMware with their Dell EMC Data Collector?

What is the recommended minimum number of ports per controller, per fault domain, to support port-level failover?

You are implementing a front-end connection in Legacy Port Mode on an SC4020 in a SAN with two iSCSI switches.

What is the minimum number of port(s), per switch, that can be used by each controller?

In an SC Series environment, which Fibre Channel zoning method is more flexible?

How many SC420 enclosures can be supported by the SC7020 controller?

You just finished racking a SC7020 array. After powering it on, you notice there is no indicator LED on the front or back of the array, but the fans are spinning.

What could be the cause?

DRAG DROP

A customer wants to map an existing volume to a new server connected through iSCSI.

What is the correct sequence of steps to complete this task?

You are required to install twenty-four (24) 3.5" 12 Gb disks on a deployed system.

Which disk enclosure would support this?

When a SC is in a failover state what will occur in the surviving controller?

The SC configuration consists of a SC7020, two (2) FC switches and four (4) Servers with a dual port FC HBA.

How many zones are required for the SC to run with virtual port mode enabled?

Refer to the exhibit.

Starting in the upper left corner of the SCv3000 what is the numerical order of the disks across the top row?

For what is Application Protection Manager used?

When creating a new server in Unisphere Central for SC Series, what should show up automatically if it has been properly configured on the host?

Which utility is used to discover and configure an uninitialized SCv2000 array?

You are implementing a front-end connection in Legacy Port Mode on an SC4020 16 Gb FC array with two FC switches.
Can full redundancy be achieved and if so, how many ports per switch can be used by the SC Series array?

What is the maximum number of drives that can be supported on an SC9000 storage array?

A customer is concerned they are over utilizing their 7K drives.

Where can information about the real time I/O usage of individual drives be viewed?

You have installed the Dell Storage Manager (DSM) Client first and then the Data Collector. When attempting to connect to the newly installed Data Collector, you receive an error message, saying: no connection could be established.

What could be the cause of this error?

You need to set up the iDRAC IP address on an SC Series controller with the following details:

IP address 192.168.0.160
subnet mask 255.255.255.0
gateway 192.168.0.1

Which commands should be used to complete this task?

A company is using an SC4020 array and the storage administrator wants to expand the available capacity by adding 92, 3.5" disk drives.

Which expansion enclosure(s) can be used to meet the demand?

A SC5020 has been installed and it is using front-end SAS. There is a problem on Server A and Server B during Controller failover. Each server has a connection in Fault Domains 1 and 2.

What is wrong?