Free CWDP-303 Exam Dumps Preview

During your first pre-deployment meeting with the deployment team, you hand out the full design documentation to all of them.

What's your primary goal during this meeting?

When performing an active site survey in an existing WLAN infrastructure, in addition to gathering throughput data, what other important function will you typically be testing at the same time?

After importing a floor plan to a predictive design tool, what should be done prior to adding APs, antennas and attenuators (e.g.
, walls)?

During an RFP analysis, one of the vendors mentioned that you'll need to upgrade your Gigabit Ethernet switches to MultiGig switches to ensure support for 802.11ac and 802.11ax, which both offer data rates over 1Gbps.

Why is this not sound advice?

You're preparing to perform a site survey for a company that processes meat. Some areas are restricted due to high-security.

What do you have to do in order to proceed with the site survey?

When deploying a new WLAN infrastructure using PoE to power the APs, you realize that a known good AP is not powering up. You use the same cable to connect your laptop and connect without any trouble.

What is the most likely reason the AP did not power up?

An engineering firm just upgraded their WLAN form nine 802.11n APS to nine 802.11ac APs. After this upgrade, they did not see any improvement in throughput.

What is the most likely cause of this result?

What limitation exists when WMM is not enabled on an 802.11n WLAN?

Switches and APs have already been chosen by your customer. All switches support 802.3bz MultiGig interfaces and APs are 4x4:4 802.11ac wave 2 capable of using dual-5GHz and have one MultiGig interface. Some cable drops for the APs will run for more than 180.5 feet (or 55 meters).
To support MultiGig, what is the best choice of cabling?