Free 3605 Exam Dumps Preview

Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green.

What is the status of the port?

A switch with Simple Loop Prevention Protocol (SLPP) did not detect a loop.

What are two reasons this occurred? (Choose two)

What does the trace level 9 3 command accomplish?

A technician is implementing a new network that contains eight Ethernet routing switch (ERS) 8600 switches and uses advanced features.

Where are two possibilities for generating license? (Choose two)

During the installation of a unified access solution, the IP address of the wireless switch interface needs to be configured on the ERS 8000.

Which IP address must be used in configuration?

A technician is configuring Multi Link trunking (SMLT) for an Ethernet routing switch (ERS) 8600 switch cluster.
To ensure the fastest possible recovery time, which feature should be avoided?

A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24 network, but does not have a console cable available.

Which statement is correct?

Confirm that RSMLT will work on a set of VLANs.

Which network design aspect should be considered?

In a unified access solution that supports mobility, the configuration must allow for the creation of mobility tunnels to the remote switch and needs the reservation of a remote switch in mobility solution?

Click the exhibit button.

SLPP has just been enabled on both core switches.
Based on the network diagram and console output from the core 1 Ethernet Routing Switch (ERS) B600 shown in the exhibit, what is the configuration error on the edge switch?

The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with subscribed failover preventing any interruption of traffic on the network?

What are the two primary benefits of this design goal? (Choose two)

A technician is configuring password levels on the Ethernet Routing Switch (ERS) 8600, and wants the manager to be able to view and edit most device settings, but not be able to change security and password settings.

Which login Level should be set for the manager?

The ERS 8000 backplane hosts an EEPROM for storage of up to 4096 MAC addresses.
The MAC addresses are automatically used up as they are assigned to which three of the following?

An existing enterprise network is using Ethernet Routing Switch (ERS) 8600 switches in the campus core. It has determined that 10 Gigabit links are required to replace the existing 1 Gigabit links 1 to the closest. This will affect 18 connections on each of the ERS 8600 switches.

Which statement describes how to accomplish this requirement in each ERS 8600 chassis?

Which steps are initial steps required to configure the Ethernet Routing Switch (ERS) 8600 in a clustered basic core configuration? (Choose three.)

Which three functions describe VPFM? (Choose three.)

After experiencing issues with XFPs, the show sys pluggable-optical-modules info CLI commands is used to find that the switch not recognize the XFPs.

Which other method can be used to view the XFP compatibility?

When configuring an Ethernet Routing Switch (ERS) 8600 for Split Multi link Trunking (SMLT). Protection against an edge switch in the factory default condition must be taken into consideration.

Which parameter WILL help prevent loops on the SMLT ports?

With release 4.0 or higher software on the Ethernet routing switch (ERS) 8300, an advanced routing license is required to enable certain features.

Which two statements ant true about the Advanced Routing License process and supported features for the ERS 8300? (Choose two.)

An engineer needs to assign an IP address of 172 25 10.31 for out of band management of an Ethernet Routing switch (ERS) 8600 switch a subnet mask of 255.255.255.192.

Which command line interface (CLI) command should the engineer use?

When configuring an Ethernet Routing Switch (ERS) 8600 redundant Installation for warm standby, which protocol is used to give the fastest recalculation of large layer 3 topology by the standby CPU, after a Master CPU failure?

A technician wants to control the routes being added to the routing table from the BGP routing table.

Which statement describes how to do this?

A technician wants to control the routes being added to the routing table from the BGP routing table.

Which statement describes how to do this?

A technician discovers that an Ethernet Routing Switch (ERS) 8300 cat5e copper link is intermittent. The link connects a distant workstation to 8348GTX port 6/2.
The cable path is undetermined at this point and it is suspected to traverse many patch panels.

How can the ERS 8300 Time Domain reflectometer tool be of help in this situation?

During a power-on or cold-start sequence, at which stage can he flags to change the operational environment of the switch be set?

In Ethernet Routing Switch (ERS) 5600 switch was added into the existing ERS 5500 stack, but ft did not form a proper stack.

Which statement describes the problem?